User manual DELONGHI PMA 6

[. . . ] PLURI-FUNCTION OVENS Instruction for the use - Installation advice KEEP IN A SAFE PLACE Before operating this oven, please read these instructions carefully Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations within this booklet are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. It may be useful in future, either to yourself or to others in the event that doubts should arise relating to its operation. [. . . ] 3. 6 13 SEMI - AUTOMATIC COOKING This is used to automatically switch off the oven after the desired cooking period has elapsed. Set the length of the cooking period by pushing the button and the () button to increase, or ( ) to decrease if you have passed the desired time (Fig. AUTO and the symbol will be illuminated. Then set the temperature and the cooking program using the function selector switch and thermostat knobs (see specific chapters). The oven is switched on and it will be switched of automatically at the end of the desired time. During cooking, the symbol remains illuminated and by pressing the button you can see the remaining cooking time. . The cooking program can be cancelled at any time by pushing the button. At the end of the cooking period, the oven and the symbol will disappear, AUTO will flash and a buzzer will sound and can be stopped by pushing any of the buttons except the ( )/ ( ) buttons. Turn the function selector switch and thermostat knobs to zero and put the programmer onto "manual" by pressing the button. P A U T O Fig. 3. 8 Electronic clock/end cooking timer The electronic programmer is a device with the following functions: ­ 24 hours clock with illuminated display ­ Timing of oven cooking with automatic switch-off (max. 99 minutes). 4 COOKING WITH AUTOMATIC SWITCH-OFF The aim of this function is to automatically stop the cooking after a pre programmed time, for a maximum period of 99 minutes. To set the cooking time, push the or button until you obtain the desired time in the display. The symbol AUTO will be shown in the display. Then you adjust the oven thermostat knob according to the required temperature. The oven will immediately start to operate and will work for the pre programmed time. Clock time can be displayed by pressing the button. Once the time has elasped, the oven will switch off automatically, the symbol AUTO will go off and an intermittent buzzer, lasting 7 minutes, will start; this can be stopped by pressing the button. Important: Before the buzzer is stopped switch off the oven manually. To cancel the cooking program at any time press the and buttons together and release the button first. ELECTRONIC CLOCK Upon immediate connection of the oven or after a mains failure, three zeros will flash on the programmer panel. To set the clock it is necessary to push the button and then, within 7 seconds, the or button until you have set the correct time. The clock will show zero after a mains failure. Attention: When the programmer display shows three flashing zeros the oven cannot be switched on. The oven can be switched on when the symbol is shown in the display. SETTING THE FREQUENCY OF THE ALARM SOUND The selection from 3 possibilities of sound can be made by pressing the button. ELECTRONIC ALARM The programmer can be used as an alarm only for a maximum period of 99 minutes. [. . . ] 10. 5 IMPORTANT: To avoid damage to the lower trim please note the following instructions. The lower trim is designed to allow for good air circulation and the correct opening of the oven door. To ensure the trim is not damaged due to the appliance being placed on the floor, the appliance should be suitably supported as in above illustrations. After installation the appliance door should be slowly opened to ensure no damage has occurred. [. . . ]