User manual DELONGHI R 030715VW EX:2

[. . . ] Check that neither the heater nor the power cable has been damaged in any way during transportation. Do not operate the heater if damaged. Fitting the brackets and castors Remove the brackets and the castors from the polystyrene packing. Fit the castors to the spindles on the brackets, pushing firmly until they click into place (fig. 1) Pull each castor to check it is fitted correctly. [. . . ] When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, to prevent freezing at minimum energy consumption. * Models with a 24 hour timer(fig. 5) To set the timer: - Check the time by your watch. If, for example it is 10 o'clock, turn the number disc of the timer in a clockwise direction until the number 10 on the disc lines up with the arrow head marker . - The heater is usually supplied with all the red "teeth" on the timer pushed into the centre for continuous operation. Each "tooth" represents 15 minutes. Using your thumbnail push the teeth to the outer rim of the timer to indicate when you require the heater to be off. - Ensure the heater is on the mains and set to the heat setting and temperature level on the thermostat as desired. - The heater will now function automatically everyday, switching on and off according to your selection (Important-the heater must always be plugged in and a heat setting selected). Radia 4 - If you wish to operate the heater without using the timer simply push all the teeth into the centre (as when the heater was first supplied). - To completely turn off the heater, turn off all the switches and remove the plug from the mains socket. Turbo heating (some models only) Some models are fitted with a hot air fan to heat the room up more quickly. To turn this function on, push the button on the fan so it clicks in. To turn it off push the button so it clicks out. PLEASE NOTE: The total (maximum) heat output of the heater with turbo fan is 1. 5kW. The following heating combinations are available: 750W fan or 800W radiator or 700W radiator 750W fan + 700W radiator 700W + 800W = 1500W radiator In other words, the hot air fan can be used independently or in conjunction with the minimum heat setting only. Cleaning and maintenance The heater should not require any maintenance. However before attempting to clean the heater, unplug from the mains and wait for it to cool (this should take around 30 minutes). It is sufficient to remove external dust with a soft, dry cloth. If necessary, remove concentrated areas of dirt with a vacuum cleaner. 5 Radia Warnings - Do not use the heater in a bathroom or in the vicinity of bathtubs, wash basins, showers or swimming pools. [. . . ] - IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. - A safety device intervenes and turns the appliance off in the event of overheating. To reactivate the heater, remove the plug from the mains, allow the appliance to cool (for about 30 minutes), remove the cause of the overheating and then plug the appliance back into the mains and turn it back on. [. . . ]