User manual DELONGHI RH 40 REG

[. . . ] OPERATE THE CONTROL SWITCH STAYING ON THE SIDE OR ON THE BACK OF THE HEATER AND NOT IN FRONT OF IT. 2 RADIANT MODEL SRI SERIES 3 SRI SERIES ASSEMBLY 1. Place the gas cylinder in the gas cylinder compartment and connect the regulator to the cylinder as shown below. To fit the back cover, insert the two tabs located on the left hand side of the back cover into the corresponding slots in the cabinet. [. . . ] When the room has reached the desired temperature, turn the thermostat knob clockwise until the 2 burners on the left go off. This way, the appliance will automatically maintain the set temperature by cycling between maximum output (3 burners) and minimum output (1 burner) and vice versa. Pre Ignition Ignition Adjustable red thermostat TURNING THE HEATER OFF · Depress the control switch and turn the knob to the "·" position the right hand panel will remain alight. (Requirements of the gas association New Zealand) · Turn the gas cylinder OFF at the valve by turning the cylinder valve clockwise. Ensure that the pilot flame extinguishes indicating that gas is no longer available. Note with all models: Please try to turn the control knob without forcing and pushing downward, to be sure that the control knob is locked on an adjusting position you require. The control knob shouldn't turn without pushing down. 6 CHANGING THE GAS CYLINDER · Ensure the heater is switched OFF to the "·" position and the gas cylinder valve is CLOSED. · Unscrew the hand wheel anticlockwise until the regulator is separated from the gas cylinder valve. The gas cylinder can now be removed for refilling. · If using a new cylinder and there is little colour in the burner it could be due to inert gas or air present in the cylinder. If this is the case run it on maximum for a period of 1 hour in a well ventilated area. If this does not work please take your bottle back for purging. CAUTION: Never disconnect the regulator from the cylinder if the heater is operating. If you smell gas, turn off the heater and gas cylinder immediately, take the appliance outside and contact your service agent, retailer or gas supplier. VENTILATION ­ USE ONLY IN A WELL VENTILATED ROOM · Never use in bedrooms, bathrooms or when asleep as adequate ventilation cannot be assured. · Do not use in rooms smaller than 18 square metres. · Ensure ventilation is more than 72cm2 eg; window must be opened at least 20mm (2cm) in the room which the heater is being operated. · Adequate ventilation must be provided in rooms which the heater is used. This ensures removal of the products of combustion and allows the entry of replacement air. It should also reduce the possibility of condensation occurring. SAFETY DEVICES The heater you have purchased is fitted with safety devices which come on in the event of malfunctioning, while the appliance is in use. If the pilot light accidentally goes out, or if the room is not sufficiently ventilated, the safety device will block the gas flow, causing the heater to go off. 7 MAINTENANCE/SERVICING · Your gas heater is fitted with an approval gas regulator and hose. Please regularly inspect them for damage or wear. A service agent can renew any worn parts. · Ensure the heater is kept free of dust. When not in use the heater should be covered and stored in a dust free place. [. . . ] 5. FAULT No spark Gas cylinder not turned on Regulator not connected Insufficient LPG Dust in the analyser REMEDY 1. Ensure knob is held down for 10 ­ 20 seconds after the pilot ignites 2. Change the position of the heater away from the air draught 1. Use in well ventilated area, please see page 7 on ventilation 4. [. . . ]