User manual DELONGHI SM 252

[. . . ] - While using this toaster, set it up so that it has plenty of space in order for air to circulate freely around it. - This appliance is suitable for cooking foods. It must not therefore be used for other purposes or altered or tampered with in any way. [. . . ] The manufacturer declines all liability if this instruction is not respected. · Operate the appliance for at least 5 minutes and air the room, in order to eliminate the "new smell" · Clean the plates using a sponge or damp cloth and then dry carefully. · Before using, carefully wash the non-stick grill. 4 SM252 6-02-2002 8:34 Pagina 5 USE Close the toaster and insert the plug. The red power indicator (6) will turn on. Slide the thermostat (8) to the maximum position. After preheating for around 4 minutes, the toaster will be ready. The green "ready for use" indicator (7) will turn on. (Always preheat the appliance before use). Slide the thermostat (8) to the desired position. The thermostat will keep the correct temperature by turning the toaster on and off intermittently. Always use this toaster in its closed position. To enchance the taste and appearance of the toasted sandwich, spread the OUTSIDE of the bread with butter or a spread suitable for cooking. Place the first slice of bread, buttered side down, on the toasters bottom plate. Then place or spread the filling on that piece of bread. Be careful not to use too much filling to the edges of the bread as this may cause the filling to overflow. At the same time, ensure there is sufficient filling for your sandwich. Finally, place the second slice of bread on the filling and then close the cover by gently pressing the handle (1) until the plates are closed. Toast the sandwiches to the degree of toasting desired. [. . . ] The colour of the correct replacement fuse cover is that as marked on the base of the plug. If your appliance is not fitted with a plug, please follow the instructions provided below: B) WARNING - THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Green and yellow: Earth E Blue: Neutral L Brown: Live N As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or coloured green or green and yellow. The blue wire must be connected to the terminal marked with the letter N or coloured black. [. . . ]