User manual DELONGHI SRI

[. . . ] DO NOT position heater alongside a wall or near curtains or arm-chairs etc. Fig. 2 Fig. 3 Fig. 4 Fig. 1 - ALWAYS face heater towards centre of room. Special care should be taken if the heater is on a surface where it can move or twist on its wheels or castors if knocked by a child or dog, etc. Minimum Clearance : 200 mm from sides, 1500 mm from front. [. . . ] Support regulator with one hand while aligning the regulator bullnose (threaded part) with the threaded gas outlet on cylinder valve. Screw regulator handwheel ANTICLOCKWISE (LEFT HAND THREAD) into gas outlet. Tighten regulator handwheel as ttight as possible by hand only. When connecting the regulator to the gas cylinder, avoid undue twisting of the flexible hose. To place the bottle in position, remove the rear panel; than put the bottle in position and replace the panel. PLACE teh cylinder in the heater cabinet so that the cylinder valve is facing into the compartment. Take care to ensure that is positioned in such a way that the flexible hose does not come into contact with the metal panels of the heater, and avoid twisting of the flexible hose. OPEN cylinder valve by turning handwheel ANTICLOCKWISE. Now refer to the lighting instruction on the heater itself. Please read carefully and follow the instructions. Do not turn the bottle upside down to use completely its content. 3 5721009100 4-12-2003 11:57 Pagina 4 Pressure regulators, rubber tubes and clips CHECK that tubing is completely over the nozzles at each end of the tubing and that it is held firmly in place by tube clips (See fig. 9). Check the expiry date and state of the rubber tube regularly. If it is past its expiry date or has been damaged, replace it with one which complies with the current regulations. Avoid bending or constricting the rubber tube when the pressure regulator is fig. This heater must be used with an approved Low Pressure Regulator which complies with SAB S1237. The regulator is required to reduce the pressure of the gas in the cylinder from about 700 kPa to about 2, 8 kpa to operate the radiant - the heating panels). Ventilation USE ONLY IN A WELL VENTILATED ROOM Adequate ventilation must be provided in rooms in which the heater is used. This ensures removal of the products of combustion and allows the entry of replacement air. The following table shows the smallest size of room suitable for each heat setting and the dimensions of the aperture which must be provided equally divided between high and low level, according with the maximum, medium or minimum power. Control knob setting 1) Position small flame (low rate) 2) Position big flame (maximum rate) 3) Position medium flame (medium rate) Room Size Room Aperture 15 m3 42 m3 105 cm 2 28. 5 m3 Safety guard The guard is to prevent risk of fire and no part of it should be permanently removed. It does not give full protection for young children or the infirm. 4 5721009100 4-12-2003 11:57 Pagina 5 OPERATING INSTRUCTIONS Lighting the heater 1. FROM « » POSITION, fully depress the control knob for 10 seconds and turn to (Small Flame) position. [. . . ] - Do not use the appliance in the mountains at high altitudes. - DIARISE: During March/April of each year check the "O" Ring Seal. 5 5721009100 4-12-2003 11:57 Pagina 6 MAINTENANCE Wipe your appliance with a soft damp cloth and only when it is switched off, cold and unplugged. Do not use solvents or abrasives detergents. Check that there is no dust blocking the air inlet or outlet grids. [. . . ]