User manual DELONGHI TRD 0615

[. . . ] Fully unfold the castors by turning them outwards (Fig. Turn the radiator back to its upright position. [. . . ] Each notch corresponds to a period of 15 minutes. At this point sections will be visible corresponding to the working periods. 4 - Set in this way the radiator will function automatically every day during the set period. (Important: the plug must remain connected to power supply). To change the programmed time period, just bring back the black notches to their original position and set the new working periods required. If you wish the appliance to function without programmed working periods push all the notches towards the centre. In this case, to turn the appliance off totally the plug must be pulled out apart from switching off, so as to avoid unnecessary working of the timer. d) Models with 12-hour mechanical timer (delay-start setting) Switch on the appliance and select the desired power and temperature settings as described above. Turn the timer knob clockwise to the number of hours desired. The appliance will then automatically switch on when this time has elapsed. MAINTENANCE Your oil filled raditor is absolutely free from maintenance, fully reliable and will give many years of trouble free service. Wipe radiator with soft damp cloth; do not use detergents or abrasives. If necessary, use a vacuum cleaner to remove any built-up dirt (fig. IMPORTANT NOTES - Do not use your heater close to bath, wash-basin, shower and swimming pool. [. . . ] The appliance is fitted with a safety device which will switch off it in case of accidental overheating. To reset, disconnect the plug from the power for 30 minutes, remove the cause of overheating then plug the appliance in again. [. . . ]