User manual DELONGHI TRD0715T

[. . . ] Your heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate the heater where it might fall into a bathtub or other water containers. Do not cover cord with throw rugs, runners, or the like. Run the cord away from traffic areas and where it will not be tripped over. [. . . ] Make sure that no pieces of polystyrene or other packaging material have been left between heating elements. If necessary, remove such pieces using a vacuum cleaner. When switching the heater on for the first time, allow it to run at full power for about two hours to get rid of a possibly unpleasant smell. Make sure that the room where the heater is placed is well ventilated during this first operation. Soft crackling sounds are normal during the heater's first operation. Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. Turn the radiator back to its upright position. CAUTION Always operate the heater in upright position only (wheels on the bottom, controls on top). Any other position could create hazardous situation!WATT ECONOMIZER To conserve energy, use the 1 or 2 position after the unit has reached the desired operating temperature. With pilot lights ON, the heater is ON!When unplugged, the timer stops and must be later re-set. Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). There is only one way it can be plugged into a power supply. If you are unable to insert the plug fully into the outlet, try again by turning it the other way. If it would still not go in, it is probably due to an obsolete outlet which should be replaced. Do not tamper with the plug or outlet to defeat the purpose of this safety mechanism. If it is 9:00 pm, turn the numbered timer disk clockwise until the number 21 on the disk coincides with the pointer (2)on the timer. Set the periods of time when you want the appliance to be on by pushing the notches (1) inward, and outward when you want the appliance to be off. Each notch (3) corresponds to a period of 15 minutes. When set, the radiator will operate automatically each day during the times programmed (important: the radiator must always be plugged into an outlet). To change the programming, move the notch back into the initial position and set the new periods of functioning. [. . . ] The warranty does not cover defects or damage of the appliance, which result from repairs or alterations to the appliance outside our factory or authorized service centers, nor shall it apply to any appliance, which has been subject to abuse, misuse, negligence or accidents. Also, consequential and incidental damage resulting from the use of this product or arising out of any breach of contract or breach of this warranty are not recoverable under this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damage, so the above limitation may not apply to you. Residents: Please contact our toll free hotline at 1-800-322-3848 or log onto our website at www. [. . . ]