User manual DELONGHI TRS 1500

[. . . ] Fit the teeth into the housing provided and lock the foot in place with the eye screw, screwing it up fully (fig. When complete, turn the radiator back into the vertical operating position. WALL MOUNTING The wall mounting kit should include: 2 x top brackets (A) 1 x bottom bracket (B) 5 x screws 5 x anchors 2 x screws for the feet 1. Chose where the panel is to be installed, making sure that: a. [. . . ] ELECTRICAL CONNECTION Before plugging into the mains, make sure the voltage of your mains supply corresponds to the value V indicated on the appliance and that the socket and power line are appropriate for the load required. CONNECT THE RADIATOR TO AN EFFICIENTLY EARTHED SOCKET ONLY. This appliance complies with directive 89/336/EEC and D. M. 476/92 on radio interference suppression. - 4. OPERATION AND USE Turning on Plug into the mains. Turn the thermostat as far as it will go to maximum position. Turn the radiator on using the switch or switches. Models with double switch (3 power levels) - button "l" pressed = minimum power (indicator light on) - button "II" pressed = intermediate power (indicator light on) - both buttons "l" and "ll" pressed = maximum power (indicator lights on) To turn the appliance off, both switches must be in the "0" position, then unplug from the mains. Adjusting the thermostat When the room has reached the required temperature, turn the thermostat slowly until a "click" is heard and no further. This temperature will be regulated automatically and kept constant by the thermostat. Frost protection function With the thermostat in the position, the top switch in the "0" position and the bottom switch in the "MED" position, the appliance keeps the room at a temperature of about 5°C, preventing freezing with minimum energy outlay. * Models with 24 hour timer Using the timer If yuo wish to use the timer, position the switch in the middle position . Setting the correct time Check the time on your watch. (16. 00), turn the dial in a clockwise direction until the number 16 is lined up with the triangular pointer (fig. 6). N. B. : Never turn the dial in an anti-clockwise direction!The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the clock must be re-set. 21 20 19 16 fig. 6 pointer To program the timer 1) Set the operating times by pushing out the notches on the dial corresponding to the period required (fig. 7) (each notch represents 15 mins. ) 2) Make sure that the timer indicates the correct time (see instructions on setting the correct time). Once programmed in this way, the appliance will repeat the pre-established program every day, if the selector is in the position. operating time 21 20 19 16 fig. 7 Timer override If you wish to override the timer settings, push the timer switch to position 1 (fig. 8) manual (timer override). To return to timed operation push the switch back to the middle position (fig. 8). NOTE: if the timer switch is at the 0 position (fig. 8), the heater is off and will not operate). 1 Manual (timer override) Timer operation 0 Heater off fig. 7 Model with "Tilt-switch" The heateris fitted with a tilt-switch which turns the appliance off if it should fall over. To restart the appliance, simply plce it upright again. Cleaning and maintenance The heater should not require any maintenance. However before attempting to clean the heater, unplug from the mains and wait for it to cool (this should take around 30 minutes). It is sufficient to remove external dust with a soft, dry cloth. [. . . ] Do not use this appliance in rooms measuring less than 4m2. When disposing of this appliance, respect legislation on disposal of oil. Do not rest the cable on the appliance when hot. Do not cover the appliance when in operation. [. . . ]