User manual DELONGHI WF 1500SDL

[. . . ] · Before using, check that the mains voltage corresponds to the voltage indicated on the appliance rating plate located under the motor head. · Connect the appliance only to power outlets with a minimum rating of 10A. In the case of appliances with double insulation (see the symbol on the specifications label) earthing is not required. · Always unplug the appliance from the power socket when not in use or before performing any maintenance or cleaning operations on the appliance. [. . . ] 1 · Remove the motor head C (Fig. 2 · Remove the wet/dry tank E using the handle on the tank (Fig. 3 5 Vacuum cleaner operation · To use the appliance as a vacuum cleaner, a minimum of 2. 5 litres of water should be poured into the tank; do not exceed the maximum level of 4 litres marked on the tank. The suction conveyor G can be removed to simplify filling the tank, (Fig. 5 ACCESSORIES Multi-function two-position brush Efficiently removes dust from floors (marble or tiled), rugs or carpets. When the pedal is pushed towards the "hard floors" symbol ( ), the bristles protrude to clean hard floors more efficiently. This position is recommended for in-depth cleaning of floors and for floors with pronounced joints. When the pedal is pushed towards the "carpets" symbol ( ), the bristles retract and the brush is ready to clean fabric surfaces and delicate floors such as parquet, marble, etc. fig. 4 The water has the function of filtering the dust, and stopping it from spreading in the environment. Wet vacuuming operation When using the appliance as a wet vacuum cleaner, up to 9 litres of water can be held in the tank. If this maximum limit is exceeded, the safety float R is activated and the appliance will stop vacuuming. In this case, empty the tank, remove the filter from the float, dry it and then put it back in place. Please note: To use the appliance as a wet vacuum cleaner after having used it as a vacuum cleaner, the tank does not need to be emptied, even if this operation can be performed without water. · Replace the tank on the trolley N, position the motor head in place and raise the handle that blocks the motor head, until it clicks into place. · Fit the hose D to the appliance, inserting the end with the bayonet into the inlet port B and then turning it clockwise (Fig. To remove it, simply turn it anticlockwise. · Fit the telescopic tube H onto the hose grip, pushing it fully into place. · Fit the accessory required for the operation being performed to the telescopic tube H or directly to the hose grip F. 6 Crevice tool Ideal for collecting crumbs, dust and small deposits and in all hard-to-get-to places. Round dusting attachment Articulated to simplify cleaning operations, this is ideal for removing dust from upholstery, furniture, books, curtains, frames and clothes. Accessory holder The trolley features 2 slots P for holding the accessories, if required (Fig. 6). Cord winder Two guides on the handle block the motor head, and allow the cord to be wound, as shown in Figure 6. Multi-function nozzle Used for cleaning sofas, upholstery, car interiors, drapes, etc. When cleaning drapes, if required, decrease the suction power by sliding the control on the handgrip of the appliance, so that the hole is fully or partially open. fig. [. . . ] 8). To replace it remove the grill that presses against the side levers (Fig. 9 Replace the filter by positioning correctly in its housing. Reposition the grid and press lightly into place. The filter must be kept clean and replaced periodically to ensure the correct operation of the appliance. [. . . ]