User manual DELONGHI WIR 2 LPG

[. . . ] GB 29-01-2004 16:33 Pagina 1 THERMOSTATICALLY CONTROLLED WALL MOUNTED VENT FREE GAS HEATER WIR2 (Equipped with Pilot Light Safety System) WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life. - Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - WHAT TO DO IF YOU SMELL GAS - Do not try to light any appliance. - Do not touch any electrical switch; do not use any phone in your building. [. . . ] Do not over tighten pipe connection to regulator. The regulator body could be damaged. CHECKING GAS CONNECTIONS WARNING: test all gas piping and connections for leaks after installing or servicing . WARNING: never use an open flame to check for a leak. Apply a non-corrosive leak detection fluid to all joints. CAUTION: For propane/LP gas, make sure external regulator has been installed between propane/LP supply and heater. See guidelines under connecting to Gas Supply, page 8. The appliance and its appliance main gas valve must be disconnected from the gas supply piping system during any pressure testing of that system pressures in excess of 1/2 psi (3. 5 Kpa). The appliance must be isolated from the gas supply piping system by closing its equipment shut-off valve during any pressure testing of the gas supply piping system at test pressure equal to or less than 1/2 psi (3, 5 kpa). Disconnect appliance with its appliances main gas valve (control valve) and equipment shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig will damage heater regulator. Cap off open end of gas pipe where equipment shutoff valve was connected. Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas or opening main gas valve located on or near gas meter for natural gas, or using compressed air. Check all joints of gas supply piping system. Apply a non-corrosive leak detection fluid to all joints. Reconnect heater and equipment shutoff valve to gas supply. * A CSA design-certified equipment shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional CSA design certified shutoff valve from your dealer. 9 Pressure regulator Regulator bracket Heater cabinet 3/8" NPT pipe nipple Ground joint union Equipment shut off valve* gas from gas meter Test gauge connection* Tee joint Reducer bushing to 1/8" NPT 1/8" NPT plug tap Tee joint Pipe nipple Cap Sediment trap 3" minimum fig. 7 GB 29-01-2004 16:33 Pagina 10 Test pressures equal or less than 1/2 PSIG (3, 5 Kpa) 1. Close equipment shutoff valve (see figure 8). Pressurize supply piping system by either opening propane/LP supply tank valve located on or near gas meter for natural gas, or using compressed air. Check all joints from gas meter for natural gas (see figure B) or propane/LP supply tank for propane /LP gas, to equipment shutoff valve (see figure C). Apply a noncorrosive leak detection fluid to all joints. [. . . ] Residues from manufacturing processes ing initial operation Heater produces whistling 1. turning control knob to HIGH position when burner is cold noise when burner is lit 1. Turn control knob to LOW position and let warm up for a 2. Dirty or partially clogged burner oriremoved from line. [. . . ]