User manual DELONGHI XM 48D

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ] Make sure that the cord is positioned so that the two screws secure it in the desired direction (Fig. After use, the appliance must always be attached to the wall support, in order to recharge it and ensure maximum operating efficiency. Motor body Transformer Motor protection filter support Motor protection filter Anello blocca-filtro Short crevice tool Crevice tool Never operate the appliance without the filter! always use original filters and accessories. If you should decide not to use the vacuum cleaner any longer, it is advisable to cut the power cord (after having unplugged it from the socket) so as to make the appliance unusable. The manufacturer declines all liability for any damage caused by the incorrect use of the appliance. Ensure that the power cord is not damaged by sharp objects. Only use extension cords that are in good condition. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. STARTING THE APPLIANCE FOR THE FIRST TIME Connect the transformer to a power socket Attach the vacuum cleaner to the support, as shown in Fig. The light will switch on to indicate that the appliance is correctly fitted in the support and is being recharged. The light always remains on when the appliance is in the support. : Before being used for the first time, or when the batteries are discharged, the vacuum cleaner must be left to charge for around 16 hours. USING THE VACUUM CLEANER Remove the vacuum cleaner from the recharging support and press the ON/OFF switch (Fig. The appliance can be used to remove dust and dirt in general, etc. 5) These tools are useful for vacuuming dust and dirt in hard-to-get-to places, such as corners, edges, drawers, etc. Warning: this appliance must not be used to vacuum liquids. CHARGE/OPERATING INDICATOR The light switches on when the appliance is in the support and when it is on. A reduction in vacuuming power together with the switching off of the light indicate that the appliance must be recharged. [. . . ] CLEANING AND MAINTENANCE To clean the outside of the appliance and the accessories, use a damp cloth and soapy water. Never clean appliance with trichloroethylene or other solvents. Never operate the appliance without the dust container or the filter. uSEFUL TIPS The battery and the transformer last longer if treated correctly. [. . . ]