User manual DELONGHI XTH 200E

[. . . ] When not in use or before cleaning or maintenance, always unplug the appliance from the mains socket. Never wash the appliance with triethylene or other solvents. Never leave the appliance turned on when unattended. Keep away from children and unfit persons. [. . . ] 1: to clean hard floors, bristles out ( Pos. 2: to clean carpets and rugs, bristles in ( ON FLOORS ). 4 Select the position of the bristles using the lever on the brush. · Multipurpose nozzle for upholstered furniture To clean upholstered furniture, mattresses, garments, car seats etc. · Crevice tool with brush To clean corners, edges, drawers, etc. To use the brush, turn the end of the tool in the direction indicated by the arrow. The bristles make the tool particularly suitable for removing dust from fabrics, furniture, books, curtains, mouldings and garments. Fig. 6 14 INSTRUCTIONS Before using the appliance, extract the power cable completely and plug into the mains. To rewind the cable, unplug and press the cable wind pedal (L) (fig. 7) . Fig. 8 Turning on To turn the appliance on and off, press the ON/OFF pedal (H) (fig. 8). Electronic suction power regulation (Fig. 9) Suction power can be varied using the electronic regulator (I) on the appliance. The electronic regulator enables suction power to be varied according to the type of surface to be treated. Maximum suction power can be used to vacuum dust from carpets or hard floors (marble, ceramics, cotto, etc. ), while reduced suction power can be used to clean curtains or other light fabrics. Fig. 9 - + Mechanical suction power regulation (Fig. 10) The hose handgrip incorporates a mechanical suction regulator. Suction can be adjusted rapidly and practically by simply moving the slide. Fig. 10 15 CLEANING Dust bag full indicator (fig. 11) The dust bag full indicator (F) signals when the dust bag needs changing or the tool being used is clogged. The dust bag should be changed before the whole length of the indicator becomes red to guarantee maximum hygiene and the quality of air emitted into the room. Fig. 11 Replacing the bag To change the dust bag, press the dust collection container release button (M) and lift the cover (fig. 12), extract the bag holder (fig. 13), remove the dust bag and throw away. Thread the new dust bag into the guides and push in as far as it will go (fig. Replace the bag holder (fig. 14b) and close the cover of the appliance pressing lightly. [. . . ] To replace, press and lift the grill (O) (fig. 16). To replace the filter, rest in position then reclose the grill with a light pressure until the clip hooks into place. If your appliance has an HEPA filter, make sure you position it with the rubber side facing the appliance. You are recommended to replace the filter at least every five dust bag changes. [. . . ]