User manual DENON DP-61F

[. . . ] If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. Do not open the bottom cover In order to prevent electric shock, do not open the bottom cover. If problems occur, contact your DENON dealer. [. . . ] Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Lightning ­ For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. this will prevent damage to the product due to lightning and power-line surges. Power Lines ­ An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. Overloading ­ Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Object and Liquid Entry ­ Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. Servicing ­ Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. refer all servicing to qualified service personnel. Damage Requiring Service ­ Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) When the power-supply cord or plug is damaged, b) If liquid has been spilled, or objects have fallen into the product, c) If the product has been exposed to rain or water, d) If the product does not operate normally by following the operating instructions. Please ensure that your machine meets the power requirements in your area. About the power switch This turntable is not equipped with a primary power switch. the power switch is incorporated in the tone arm of the turntable. The power to the turntable is cut when the tone arm returns to the tone arm rest. Note however, that the power is not completely turned off in this case. If you wish to completely turn the power off, disconnect the power cord from the household AC outlet. Protect the turntable too ⷠUse only a household AC power source. Make sure that the turntable is well ventilated and away from direct sunlight. ⷠTo avoid damage to the internal circuits and the external surface, keep it away from heat (stoves, etc. Avoid using spray type insecticide near the turntable it can damage the finish and might ignite suddenly. ⷠTo avoid damaging the finish, never use paint thinner or other similar chemicals to clean the turntable. [. . . ] This unit has built-in RIAA equalizer amplifier, so it can be connected to an amplifier without PHONO (turntable) input jack. according to the amplifier , set the EQUALIZER AMPLIFIER SWITCH. When the unit is connected to the PHONO (MM) jacks: When the unit is connected to the AUX jacks, etc: Loose connections can lead to distortion. To prevent damage to cords, connect and disconnect by holding the plug, not the cord. [. . . ]