User manual DENON DRR-M33

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Allow for sufficient heat dispersion when installed on a rack. Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. [. . . ] € If the heads are dirty, sound cannot be recorded or played with good quality. € To take full advantage of this product’s performance and to achieve good sound quality, clean the heads periodically after approximately 10 hours of use. € We recommend using a wet type commercially available head cleaning cassette that also cleans the pinch roller and capstan. 7 LINE IN (analog input) terminals Degaussing the Heads • The heads become magnetized after extended use or after being exposed to magnetized objects. This results in noise or a loss of high frequencies. € Use a commercially available cassette type head degausser to demagnetize the heads. NOTE: • Set the amplifier’s volume to the minimum when cleaning and degaussing the heads. • Press to reverse the direction of tape playback or recording. € Press this button to rewind the front side of the tape. (The back side of the tape is fast-forwarded. High tape (TYPE II) A The DRR-M33 is equipped with an auto tape selector mechanism which uses the detection holes in the cassette halves to detect the type of tape and automatically set the most appropriate recording bias and equalization for that type of tape. Detection holes Reverse A (2) Auto Tape Select Mechanism A A A NOTES: • If a foreign object is caught in the cassette tray during closing, simply press the 5 (open/close) button again and the tray will open. € Do not press the cassette tray in by hand when the power is off. € Do not place foreign objects in the cassette tray. 6 8:50 ページ 8 ENGLISH 8 PLAYBACK (1) Starting Playback 2 2, 3 7 (2) Stopping Playback 1 (3) Fast-forwarding and Rewinding z To fast-forward the tape 1 x To rewind the tape 1 1 5 6 4 2 2 1 Turn on the power. 1 Load the cassette tape you want to play. 2 ✽ Load the cassette tape with side A facing up. NOTE: • Be sure to press the 2 (stop) button to stop playback before turning off the power or unplugging the power supply cord. 6 Press the 0 1 (direction) button to change the direction of playback. 6 8:50 ページ 9 ENGLISH (4) Using the Music Search Function Example 1: Finding the beginning of the 4th selection on front side while playing the 1st selection. Example 2: Finding the beginning of the 2nd selection on front side while playing the 4th selection. During playback, press the 7 (fast-forward) button three times. [. . . ] Are all system components being operated correctly in accordance with the operating instructions?If the tape deck still does not function properly, check the symptom against the list below. If the symptom does not correspond to the check list, please contact your DENON dealer. Symptom Recording does not start when REC button is pressed. [. . . ]