User manual DENON RC-8000

[. . . ] REMOTE CONTROL UNIT RC-8000 OPERATING INSTRUCTIONS MODE D'EMPLOI ¥)) FOR ENGLISH READERS POUR LES LECTEURS FRANCAIS PAGE 42 ~ PAGE 33 PAGE 34 ~ PAGE 65 "SERIAL NO. PLEASE RECORD UNIT SERIAL NUMBER ATTACHED TO THE REAR OF THE CABINET FOR FUTURE REFERENCE" "NO. DE SERIE PRIERE DE NOTER LE NUMERO DE SERIE DE L'APPAREIL INSCRIT A L'ARRIERE DU COFFRET DE FAÇON A POUVOIR LE CONSULTER EN CAS DE PROBLEME. " ENGLISH 2 We greatly appreciate your purchase of this unit. 2 To be sure you take maximum advantage of all the features this unit has to offer, read these instructions carefully and use the set properly. [. . . ] To select other devices, press the JOG switch's ENTER button to display the icon display section, then select the device. Screen w Screen e 20 ENGLISH r Press the and buttons in the icon display section to display the DVD icon, then press the DVD icon to select it. Here, press the DVD "ON" and "PLAY" buttons. To select buttons on other pages, press the JOG switch's left and right buttons to switch the page. After the buttons are registered, press the "END" button. When the "END" button is pressed, the display switches to a confirmation screen. t The buttons registered in steps e and r are displayed on the confirmation screen. Press the "OK" button to register the system call settings. The system call button name switches from gray to black. The system call signals are stored at the open system call button with the lowest number. Initially they are stored at "CALL 1". Screen r Screen t [3] Editing registered system call settings q Press "SETUP" on the icon display section for 3 seconds to display the setup screen. Call Setup" button on the "Setup 3/4" page to display the system call selection screen. w Press the and buttons on the call list to display the system call button you want to edit. Press the system call button you want to edit so that it is displayed in half-tone dot mesh, then press the "EDIT" button to set the system call edit mode. e Editing system call settings e-1 Changing the delay time By default, the delay time is set to 0. 7 seconds. The delay time can be changed to anything between 0 and 10 seconds in steps of 0. 1 second. The delay times at the right of the buttons indicate the time from which the signal for that button is sent until the signal for the next button is sent. Press the button on the system call editing screen's button list whose delay time you want to change so that it is displayed in half-tone dot mesh. Press the · and ª buttons at the bottom right of the editing screen to set the desired delay time. Screen q Screen w Screen e 21 ENGLISH e-2 Deleting buttons a. At the system call editing screen, press the button you want to delete so that it is displayed in halftone dot mesh. At the system call editing screen, press the button you want to move so that it is displayed in halftone dot mesh. Press the "Move" button, then press the button at the position to which you want to move the first button. [. . . ] w Use the and buttons on the device name list to display the device for which you want to perform RF transmission. Press the icon for that device to switch the setting from IR to RF. Press the "OK" button to complete the setting and return to the setup screen. The setting switches between RF and IR each time the button is pressed while it is displayed with a halftone dot mesh. [. . . ]