User manual DENON TU-1500RD

[. . . ] Whenever the apparatus is in the STANDBY state, the apparatus is still connected to AC line voltage. Please be sure to unplug the cord when you leave home for, say, a vacation. Vid installationen av produkten ska du se till att eluttaget den ansluts till är nära utrustningen. Allow for sufficient heat dispersion when installed in a rack. [. . . ] Do not press buttons on the main unit and remote control unit simultaneously. Neon signs or other devices emitting pulse-type noise nearby may result in malfunction, so keep the unit as far away from such devices as possible. For details on the functions of these parts, refer to the pages given in parentheses ( ). When pressed, the power turns on and the display lights. The muting mode is set for several seconds, after which the TU-1500RD will function normally. When pressed again, the power is set to the "standby" mode and the display turns off. When pressed while the FM band is set, the TU-1500RD searches for stations that can be received in stereo and up to 100 stations are automatically stored at the preset channels. (The stations are stored in order starting from channel A1. In the AUTO mode, this lights when a stereo broadcast is tuned in. This lights when the strength of the reception frequency is at or above a specific level. When in the tuning mode, use this knob to raise or lower the frequency. In the auto tuning mode, press the TUNING button, the automatic searching begins, them stops when a station is tuned in, In the manual tuning mode, press the TUNING button, the frequency changes continuously. Use these to change the received frequency to a higher frequency (· Do not connect two FM antennas simultaneously. Even if an external AM antenna is used, do not disconnect the AM loop antenna. Make sure the AM loop antenna lead terminals do not touch metal parts of the panel. Use the installation hole to secure the antenna to a wall, etc. The hookup diagrams on the subsequent pages assume the use of the following optional connection cables. Turning the power on 2 Setting the power to the "on" mode 2 Setting the power to the "standby" mode When the power is in the "on" mode, press the ON/STANDBY or POWER button. If a station's signal is too weak to tune in using auto preset mode, preset it manually. FM broadcast stations are automatically searched for and stored in order at the preset channels, starting from "A1". When the first FM broadcast station is found, that station is stored in the preset memory at channel "A1". Subsequent stations are automatically stored in order at preset channels A1 to A10, B1 to B10, C1 to C10, D1 to D10, E1 to E10, F1 to F10, G1 to G10, H1 to H10, I1 to I10 and J1 to J10 for a maximum of 100 stations. [. . . ] The preset channel number can also be selected using the PRESET + and ­ buttons. RDS (works only on the FM band) is a broadcasting service which allows a station to send additional information along with the regular radio programme signal. The following three types of RDS information can be received with this unit: This allows you to easily find out the latest traffic conditions in your area before leaving home. The programme types and their displays are as follows: NEWS AFFAIRS INFO SPORT EDUCATE DRAMA CULTURE SCIENCE VARIED POP M ROCK M EASY M News Current Affairs Information Sports Education Drama Culture Science Varied Pop Music Rock Music Easy Listening Music Light Classical Serious Classical SOCIAL RELIGION PHONE IN TRAVEL LEISURE JAZZ COUNTRY NATION M OLDIES FOLK M DOCUMENT OTHER M WEATHER FINANCE CHILDREN Other Music Weather Finance Children's Programmes Social Affairs Religion Phone In Travel Leisure Jazz Music Country Music National Music Oldies Music Folk Music Documentary · The operations described below pressing the DISPLAY button will not function in areas in which there are no RDS broadcasts. [. . . ]