User manual DEWALT D21620K

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. & Ireland only) Power input No-load speed Maximum drilling range in steel with annular cutter Tool holder (Weldon Shank) Spindle thread size Weight Fuses: Europe U. For more information, please contact DEWALT at the address below, or refer to the back of the manual. KpA (sound pressure uncertainty) KWA (acoustic power uncertainty) The following symbols are used throughout this manual: Denotes risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instructions in this manual. [. . . ] Keep the magnet clean and free of debris and swarf. Do not switch on the machine until it has been mounted and installed according to the instructions. Do not switch on the machine before having checked that the magnetic stand has been tightened firmly to the mounting surface. Do not perform any design, assembly or construction activities on the workpiece while the machine is switched on. Before switching on the machine, make sure the accessory has been mounted correctly. Always use the recommended speed for the accessories and the material. Do not use the machine on the same workpiece on which electric welders are being used. Use a general non-oil-based metal cutting coolant diluted with water. Do not use liquid cutting fluids while drilling vertically or overhead. Do not pour cutting fluid into the reservoir while it is mounted in the bracket. Do not allow cutting fluid to enter the drill motor. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. If an extension cable is required, use an approved extension cable suitable for the power input of this machine (see technical data). When using a cable reel, always unwind the cable completely. Always check that the power supply corresponds to the voltage on the rating plate. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. attach the wires to their respective points in the plug (see below). [. . . ] Switching the power on and off · The power indicator will start blinking until the mains plug is disconnected. Activating the magnet The magnet can only be activated when the power is switched on. To switch off the magnet, press the yellow button again. Before releasing, the magnet will remain engaged for 3 more seconds, which is indicated by the yellow indicator blinking until it goes off. [. . . ]