User manual DEWALT D23650K

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. & Ireland only) Power input No-load speed Depth of cut Blade diameter Blade body thickness Blade bore Bevel angle adjustment Weight Fuses: Europe U. For more information, please contact DEWALT at the address below, or refer to the back of the manual. D23650 LpA (sound pressure) LWA (acoustic power) Weighted RMS acceleration value KpA (sound pressure uncertainty) KWA (acoustic power uncertainty) dB(A) dB(A) m/s2 dB(A) dB(A) 3 3 98 109 2. [. . . ] h Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially designed for your saw, for optimum performance and safety of operation. Further safety instructions for all saws Causes and operator prevention of kickback: - kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw to lift up and out of the workpiece toward the operator; - when the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator; - if the blade becomes twisted or misaligned in the cut, the teeth at the back edge ofthe blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back toward the operator. Kickback is the result of saw misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below. A Maintain a firm grip with both hands on the saw and position your arms to resist kickback forces. Position your body to either side of the blade, but not in line with the blade. Kickback could cause the saw to jump backwards, but kickback forces can be controlled by the operator, if proper precautions are taken. B When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. investigate and take corrective actions to eliminate the cause of blade binding. C When restarting a saw in the workpiece, centre the saw blade in the kerf and check that saw teeth are not engaged into the material. If saw blade is binding, it may walk up or kickback from the workpiece as the saw is restarted. D Support large panels to minimise the risk of blade pinching and kickback. Large panels tend to sag under their own weight. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel. F Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback. G Use extra caution when making a , , plunge cut" into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback. Safety instructions for saws with a pendulum blade guard a Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. [. . . ] Whenever possible, connect a dust extraction device designed in accordance with the relevant regulations regarding dust emission. Always use a vacuum extractor designed in compliance with the applicable Directives regarding dust emission when sawing wood. Vacuum hoses of most common vacuum cleaners will fit directly into the dust extraction outlet. Do not use a vacuum extractor without proper spark protection when sawing metal. [. . . ]