User manual DEWALT D27300T

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. Voltage Power input Power output No-load speed Feed speed Cutting height (max. For more information, please contact DEWALT at the address below or refer to the back of the manual. The following symbols are used throughout this manual: Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of the instructions in this manual. [. . . ] When working long pieces, use a suitable roller table on both sides of the machine adjusted to the height of the tables. Keep your hands well clear off the blades. In the thicknessing mode, never plane material shorter than 305 mm. In the planing mode, use a push stick at all times. Keep the push stick in its place when not in use. Residual risks The following risks are inherent to the use of planers: In spite of the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be avoided. These are: - Risk of accidents caused by the uncovered parts of the rotating blade. - Health hazards caused by breathing dust developed when planing wood, especially oak, beech and MDF. Labels on tool The following pictograms are shown on the tool: A1 1 On/off switch 2 Elevating handle 3 Lower table 4 Shavings collector 5 Scale lower table 6 Push stick 7 Fence clamp handle 8 Fence Fig. Read the instruction manual before use When using the machine in the thicknessing mode, be aware of the direction of feed. Never use the machine without shavings collector in position. When using the machine in the planing mode, be aware of the direction of feed. Never use the machine without shavings collector in position. Make sure that the cutting blades are properly adjusted. Do not allow the blades to protrude from the cutterhead by more than 1. Always check that the power supply corresponds to the voltage on the rating plate. The package contains: 1 Partly assembled thickness planer 1 Guard 1 Shavings collector 1 Box containing: 1 Fence 1 Push stick 1 Bag containing: 1 Allen key 2. 5 mm 1 Allen key 4 mm 1 Allen key 5 mm 1 Allen key 6 mm 1 Spanner 13/10 mm 1 Adjustment gauge 1 Elevating handle 2 Clamp handles 4 Rubber feet 1 M8 coach bolt 4 M8 nuts 4 D8 toothed washers 1 D8 flat washer 1 Box containing: 4 Legs 2 Wheels 2 Wheel brackets 1 Bag containing: 2 Wheel axles 4 M8 coach bolts 2 M8 hex head bolts 4 M8 nuts 4 Wing nuts 4 D8 flat washers 6 D8 Belleville washers 1 Instruction manual 1 Exploded drawing · Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. If an extension cable is required, use an approved extension cable suitable for the power input of this machine (see technical data). When using a cable reel, always unwind the cable completely. Three-phase machines should be wired directly into the mains by a suitably qualified electrician. [. . . ] Always switch off the machine when work is finished and before unplugging. Slowly feed the workpiece underneath the guard, keeping it firmly pressed against the fence. Remember to use the push stick when close to the cutterhead. Best results are achieved when the workpiece has at least one flat surface. [. . . ]