User manual DEWALT DC330KB

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. Power output No-load speed Stroke length Cutting depth in: - wood - aluminium - steel Bevel angle adjustment (l/r) Weight (without battery pack) Battery pack Battery type Voltage Capacity Weight Charger Mains voltage Battery type Approx. For more information, please contact DEWALT at the address below, or refer to the back of the manual. 8 LWA (acoustic power) Weighted RMS acceleration value KpA (sound pressure uncertainty) KWA (acoustic power uncertainty) The following symbols are used throughout this manual: Denotes risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instructions in this manual. [. . . ] In case of skin contact, flush immediately with water. neutralize with a mild acid such as lemon juice orvinegar. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. Never attempt to open a battery pack for any reason. Labels on charger and battery pack In addition to the pictographs used in this manual, the labels on the charger and the battery pack show the following pictographs: Do not probe with conductive objects Read instruction manual before use Use only with DEWALT battery packs, others may burst, causing personal injury and damage Do not expose to water Have defective cords replaced immediately Charge only between 4 °C and 40 °C Discard the battery pack with due care for the environment 8 Shoe 9 Pendulum stroke selector 10 Shoe lever 11 Battery pack Charger Your charger DE9116 accepts DeWALT NiCd/NiMH battery packs ranging from 7. Do not incinerate the battery pack Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Your DEWALT charger is double insulated in accordance with EN 60335. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly ratedfuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Your jigsaw DC330 has been designed for professional cutting of wood, steel, aluminium, plastic and ceramic material. 1 Variable speed switch 2 Safety lock 3 Sawdust blower control 4 Blade latch 5 Finger guard 6 Blade holder 7 Guide roller To charge the battery pack (11), insert it into the charger (13) as shown and plug in the charger. Be sure that the battery pack is fully seated in the charger. 1 hour, it will stop blinking and remain on. The battery pack can be removed at any time or left in the connected charger for a longer period of time (with a maximum of 14 days). Never connect the live (L) or neutral (N) wires to the earth pin marked E or . [. . . ] Check that there is sufficient space for the blade underneath the workpiece. Using a conventional blade, cut up to the projected edge. Finish off the cut using a flush cutting blade. Your DEWALT power tool has been designed to operate over a long period of time with a minimum of maintenance. [. . . ]