User manual DEWALT DC989VA

[. . . ] A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. C) Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire. D) When battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. [. . . ] RBRCTM in cooperation with DEWALT and other battery users, has established programs in the United States to facilitate the collection of spent nickel-cadmium batteries. Help protect our environment and conserve natural resources by returning the spent nickel-cadmium battery to an authorized DEWALT service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery. Before using charger, read all instructions and cautionary markings on charger, battery pack, and product using battery pack. Do not allow any liquid to get inside charger. To reduce the risk of injury, charge only DEWALT nickel cadmium rechargeable batteries. â· Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire. â· Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk. Do not attempt to use it on any other voltage. This does not apply to the vehicular charger. Your battery can be charged in DEWALT 1 Hour Chargers, 15 Minute Chargers or Vehicular 12 volt charger. Be sure to read all safety instructions before using your charger. Consult the chart on the back cover of this manual for compatibility of chargers and battery packs. When changing the position of the control button, be sure the trigger is released. NOTE: The first time the tool is run after changing the direction of rotation, you may hear a click on start up. This is normal and does not indicate a problem. Your tool has an adjustable torque screwdriver mechanism for driving and removing a wide array of fastener shapes and sizes and in some models, a hammer mechanism for drilling into masonry. Circling the collar (C) are numbers, a drill bit symbol, and in some models, and a hammer symbol. [. . . ] Dirt and grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions. To turn the tool off, release the trigger switch. the chuck will stop as soon as the trigger switch is fully released. [. . . ]