User manual DEWALT DW152

[. . . ] 11 Do not overreach Keep proper footing and balance at all times. 12 Avoid unintentional starting Do not carry the plugged-in tool with a finger on the switch. Be sure that the switch is released when plugging in. Do not operate the tool when you are tired. [. . . ] 19 Check for damaged parts Before using the tool, carefully check it for damage to ensure that it will operate properly and perform its intended function. Check for misalignment and seizure of moving parts, breakage of parts and any other conditions that may affect its operation. Have damaged guards or other defective parts repaired or replaced as instructed. 20 Have your tool repaired by an authorized DEWALT repair agent This Power Tool is in accordance with the relevant safety regulations. to avoid danger , electric appliances must only be repaired by qualified technicians. The tool can be mounted on a drill stand for use as a stationary tool. Always check that the power supply corresponds to the voltage on the rating plate. Your DEWALT tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Your DEWALT heavy duty drill has been designed for professional applications: DEWALT DW152 drill - heavy duty mixing, thread tapping and drilling. To remove the accessory insert the drift wedge (9) into the drift wedge slot (10) and strike it with a hammer. B) The tool is equipped with two removable side handles (6 & 7) to operate the drill when it is used as a hand-held tool. threaded side handle · Screw the handle (6) into position and tighten it. control side handle · Mount the handle (7) onto the gear housing (11) using the four hexagonal screws (14) provided. B) The breast plate (12) enables optimal control of the drill when it is used as a hand-held tool. [. . . ] Apply only a gentle pressure to the tool. Always switch OFF the tool when work is finished and before unplugging. Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Take your tool to an authorized DEWALT repair agent where it will be disposed of in an environmentally safe way. [. . . ]