User manual DEWALT DW411

[. . . ] Proper footing and balance enables better control of the tool in unexpected situations. Dust mask, non-skid safety shoes, hard hat, or hearing protection must be used for appropriate conditions. tOOL USE AND CARE · Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. [. . . ] " These cords are rated for outdoor use and reduce the risk of electric shock. minimum Gage for Cord Sets Volts Total Length of Cord in Feet 120V 0-25 26-50 51-100 101-150 240V 0-50 51-100 101-200 201-300 Ampere Rating More Not more AWG ThanThan 0 6 18 16 16 14 6 - 10 18 16 14 12 PERSONAL SAFETY · Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury, · dress properly. Keep your hair, clothing , and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts. Air vents often cover moving parts and should also be avoided. Be sure switch is off before plugging in. Remove adjusting keys or wrenches before turning the tool on. A wrench or a key that is left attached to a rotating part of the tool may result in personal injury. Your DEWALT tool is powered by a DEWALT built motor. Be sure your power supply agrees with the nameplate marking (Volts, 120 AC only). A Voltage decrease of more than 10% will cause loss of power and overheating. All tools DEWalt tools are factory tested; if this tool does not operate, check the power supply. Your sander is designed to use 1/4 sized sanding sheets. For normal operations, assemble the abrasive paper to your unit as follows. Release clamp by pulling up on clamp lever and disengaging it from the tab on the base plate. Insert the 4-1/2" edge of the abrasive paper under the front paper clamp, as shown in Figure 3 until it hits the paper limiting ribs shown in the figure. Close the front paper clamp and hook it into the lock position behind the tab on the base plate. If you are using the dust extraction feature, perforate the sand- paper with the provided paper punch as shown in Figure 5. To turn the unit on, depress the side of the dust protected switch that corresponds to the symbol "I". To turn the tool off, depress the side of the switch that corresponds to the symbol "O". [. . . ] Ordinary painting masks do not offer this protection. See your local hardware dealer for the proper N. NO EATING, DRINKING or SMOKING should be done in the work area to prevent ingesting contaminated paint particles. Workers should wash and clean up BEFORE eating, drinking or smoking. [. . . ]