User manual DEWALT DW433K

[. . . ] 3 Keep children away Do not allow children, visitors or animals to come near the work area or to touch the tool or the mains cable. 4 Dress properly Do not wear loose clothing or jewellery, as these can be caught in moving parts. Wear protective hair covering to keep long hair out of the way. When working outdoors, preferably wear suitable gloves and non-slip footwear. [. . . ] 18 Store idle tools When not in use, tools must be stored in a dry place and locked up securely, out of reach of children. 19 Maintain tools with care Keep the tools in good condition and clean for better and safer performance. follow the instructions for maintenance and changing accessories. Keep all handles and switches dry, clean and free from oil and grease. 20 Repairs This tool is in accordance with the relevant safety regulations. have your tool repaired by an authorised DEWALT repair agent. Repairs should only be carried out by qualified persons using original spare parts; otherwise this may result in considerable danger to the user. sanding paint Observe the applicable regulations for sanding paint. Pay special attention to the following: 1 Whenever possible, use a vacuum extractor for dust collection. 2 Take special care when sanding paint which is possibly lead based: · Do not let children or pregnant women enter the work area. All persons entering the work area should wear a mask specially designed for protection against lead paint dust and fumes. Do not eat, drink or smoke in the work area. Take the time to thoroughly read and understand this manual prior to operation. Always check that the power supply corresponds to the voltage on the rating plate. Your DeWALT tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DeWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Check for damage to the tool, parts or accessories which may have occurred during transport. [. . . ] Excessive pressure does not improve the sanding effect, but only results in an increased load on the machine and causes the abrasive to tear. Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Take your tool to an authorized DEWALT repair agent where it will be disposed of in an environmentally safe way. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. [. . . ]