User manual DEWALT DW650

[. . . ] Be sure that the switch is released when plugging in. Do not operate the tool when you are tired. 14 Disconnect tool Shut off power and wait for the tool to come to a complete standstill before leaving it unattended. Unplug the tool when not in use, before servicing or changing accessories. [. . . ] Pay special attention to the following: 1 Whenever possible, use a vacuum extractor for dust collection. 2 Take special care when sanding paint which is possibly lead based: · Do not let children or pregnant women enter the work area. All persons entering the work area should wear a mask specially designed for protection against lead paint dust and fumes. Do not eat, drink or smoke in the work area. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Your DEWALT high performance Belt Sander DW650(E) has been designed for professional sanding of wood, wood products and plastics. Always check that the power supply corresponds to the voltage on the rating plate. Your DEWALT tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Place the tool on its side with the clamping lever (12) upwards. Place a new sanding belt making sure that the arrow on the inside of the sanding belt points in the same direction as the arrow on the machine when on the same side of the rollers. Switch the machine ON and turn the outer belt centring knob (6) until the sanding belt is centred on the roller (11). the sanding belt should never project at the rear!The sanding belt should be flush with the outer edge of the sanding surface. Turn the speed control dial (2) to the desired position. The higher the number, the higher the belt speed. [. . . ] Continuous satisfactory operation depends upon proper tool care and regular cleaning. GUARANTEE Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Regularly empty the dustbag or clean the dust extraction adaptor. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to a participating Dealer, or an authorized DEWALT repair agent, for a full refund or exchange. [. . . ]