User manual DEWALT DW735

[. . . ] WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following: WARNING: For your own safety, read the instruction manual before operating the planer. Failure to heed these warnings may result in personal injury and serious damage to the planer. When servicing this tool, use only identical replacement parts. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. [. . . ] It is used to indicate the amount of wood that will be removed in one pass with the carriage set at its current height. Slide approximately 3" of your material under the middle of the carriage. Be sure the wood is lying flat against the base of the planer. Crank the carriage down on the material until the material removal bar engages the wood. You will see the red arrow begin to move up the scale indicating the amount of material to be removed with the carriage at that height. Adjust the carriage height until the desired depth of cut appears on the gauge. Pull the material out from under the carriage. Turn the unit on and feed your material into the cutter head. NOTE: Do not exceed the recommended depth of cut for various widths of material recommended on the material removal gauge. Your planer is equipped with a fan-assisted chip ejection system to aid in exhausting chips from the unit. The fan-assisted chip ejection system will work in conjunction with independent dust collection systems. NOTE: It is not recommended that a shop vac be connected to the DW735. The capacity of most vacs does not support the volume of chips ejected during planing. There is no manual carriage lock on your planer. A device that automatically minimizes the movement that causes snipe during planing is designed into the four threaded posts. Your planer has the ability to feed material at two different speeds. The two-speed feature (P) was designed to improve efficiency when planing and to provide the best possible surface finish to a variety of materials. To remove material thickness more quickly, set the unit at speed "2". this setting delivers 96 cuts per inch to the material. For finishing, set the unit to speed "1". Speed "1" is ideal for ensuring the finest finish on the last pass before your final thickness is achieved. NOTE: When planing particularly hard or figured species of wood, speed "1" is recommended. [. . . ] The T-wrench on your planer can be used to turn the stepped bolt until it is fully secured (Fig. Install the smaller Allen screw into the lower threaded hole on the side of the base. Depress the top Allen pin until it is flush with the base and slide the top hole of the table over the pin and release the pin so they lock together (Fig. To attach the table to the rear of the planer, install the bolts and spring following the above procedure. [. . . ]