User manual DEWALT DW934K2

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. Voltage Power output No-load speed Blade diameter Depth of cut Blade body thickness Blade bore Weight (without battery pack) Battery pack Voltage Capacity Weight Charger Mains voltage Charging time Weight Fuses: Europe U. For more information, please contact DEWALT at the address below, or refer to the back of the manual. Level of sound pressure according to 86/188/EEC & 98/37/EEC, measured according to EN 50144: Take appropriate measures for the protection of hearing if the sound pressure of 85 dB(A) is exceeded. [. . . ] Do not probe with conductive objects Read instruction manual before use Use only with DEWALT battery packs, others may burst, causing personal injury and damage Do not expose to water Have defective cords replaced immediately Ensure that all devices screening the saw blade are in perfect working order. Free a jammed saw blade guard immediately and do not use the saw if the guard is jammed. guard against kickback · Kickback occurs when the saw begins to stall rapidly and is driven back towards the operator. Release the switch immediately if the blade sticks or the saw stalls. Do not remove the saw from the work during a cut while the saw blade is rotating. checking and changing the saw blade · Use only the saw blades specified in this manual. Never use abrasive cut-off wheels or other types of cutting blade. Only sharp saw blades in perfect working condition should be used; cracked or bent saw blades should be discarded and replaced at once. Ensure that the saw blade is securely fixed and rotates in the correct direction. applications · The circular saw must only be used for ferrous metal. Do not cut non-ferrous metals, stainless steel and synthetic materials when using the saw blade supplied with this tool. Rods) with a body thickness exceeding 20 mm. Do not cut profiles and other shaped materials (e. Pipes, boxes) with a wall thickness exceeding 3 mm. When sawing with the workpiece clamped tight, devices should be used to prevent the workpiece kicking back. When sawing circular sections of metal use a device to hold the workpiece steady on both sides of the saw blade to prevent slipping. Take care that pieces of metal sawn off the workpiece cannot be caught up by the teeth of the saw blade and thrown in the air. Use of this tool can generate dust containing chemicals known to cause cancer, birth defects or other reproductive harm. use appropriate respiratory protection. Residual risks The following risks are inherent to the use of these machines: - injuries caused by touching the rotating parts - injuries caused by disruption of the cutting blade These risks are most evident: - within the range of operation - within the range of the rotating machine parts In spite of the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be avoided. The package contains: 1 Metal cutting circular saw 1 Saw blade 1 Allen key 2 Battery packs 1 Battery charger 1 Kitbox 1 Instruction manual 1 Exploded drawing · Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. [. . . ] inserting and removing the battery pack · Insert the battery pack into the grip until it clicks in place. To remove the battery pack, press the two release buttons (11) simultaneously and pull the pack out of the grip. Without the protective cap in place, loose metal objects could short circuit the contacts, causing a fire hazard and damaging the battery pack. Take off the protective cap (14) before placing the battery pack (10) in the charger or tool. [. . . ]