User manual DEWALT DW936

[. . . ] Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional Power Tool users. The following symbols are used throughout this manual: Denotes risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instructions in this manual. For more information, please contact DEWALT at the address below or refer to the back of the manual. Level of sound pressure according to 86/188/EEC & 89/392/EEC, measured according to EN 50144: Power output W No load speed min-1 Blade diameter mm Depth of cut mm Blade body thickness mm Blade bore mm Bevel angle adjustment Weight (without battery pack) kg Battery pack Voltage Capacity Weight Charger Mains voltage Charging time Weight Fuses: Europe U. [. . . ] Saw blades made of high alloy, high speed steel (HSS steel) should not be used. Only sharp saw blades in perfect working condition should be used; cracked or bent saw blades should be discarded and replaced at once. Ensure that the saw blade is securely fixed and rotates in the correct direction. special applications · When cutting narrow workpieces (width less than 80 mm) longitudinally, use a rip fence guide along the longitudinal edge. When sawing with the workpiece clamped tight, devices should be used to prevent the workpiece kicking back. When sawing circular sections of wood use a device to hold the workpiece steady on both sides of the saw blade to prevent slipping. Ensure that pieces of wood sawn off the workpiece cannot be caught up by the teeth of the saw blade and thrown in the air. guard against kickback · Kickback occurs when the saw begins to stall rapidly and is driven back towards the operator. Release the switch immediately if the blade sticks or the saw stalls. Supports large panels near the cutting area. Use a fence or straight edge guide when ripping; do not force the tool. Do not remove the saw from the work during a cut while the saw blade is rotating. 1 Instruction manual 1 Exploded drawing · Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. 1 ON/OFF-switch 2 Lock-off button 3 Front handle 4 Blade lock button 5 Dust spout 6 Bevel adjustment knob 7 Kerf indicator 8 Riving knife 9 Blade clamping screw 10 Lower guard 11 Lower guard retracting lever 12 Shoe 13 Depth adjustment knob 14 Parallel fence (DW936K2) 15 Battery pack Charger Your DEWALT 1 hour charger accepts DEWALT battery packs ranging from 7. Always check that the battery pack power corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Your DEWALT charger is double insulated in accordance with EN 50144. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). [. . . ] Press the blade lock button (4) while turning the spindle until the blade stops rotating. Tighten the blade clamping screw firmly using the Allen key. E) For the correct adjustment of the riving knife (8), refer to the inset in figure E. Adjust the clearance of the riving knife after changing the saw blade or whenever necessary. [. . . ]