User manual DEWALT DW955K

[. . . ] 10 Do not overreach Keep proper footing and balance at all times. Do not operate the tool when you are tired. 12 Remove adjusting keys and wrenches Always check that adjusting keys and wrenches are removed from the tool before operating the tool. 13 Use appropriate tool The intended use is described in this instruction manual. [. . . ] Use an approved extension cable suitable for the power input of your charger (see technical data). Always switch OFF the tool before inserting or removing the battery pack. A) Charging the battery pack When charging the battery pack for the first time, or after prolonged storage, it will only accept an 80% charge. After several charge and discharge cycles, the battery pack will attain full capacity. always check the mains prior to charging the battery pack. If the mains is functioning but the battery pack does not charge, take your charger to an authorised DEWALT repair agent. whilst charging , the charger and the battery pack may become warm to touch. This is a normal condition and does not indicate a problem. Do not charge the battery pack at ambient temperatures <4 °C or >40 °C. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. To charge the battery pack (6), insert it into the charger (8) as shown and plug in the charger. Be sure that the battery pack is fully seated in the charger. 1 hour, it will stop blinking and remain on. The battery pack can be removed at any time or left in the connected charger indefinitely. inserting and removing the battery pack · Insert the battery pack into the grip until it clicks in place. To remove the battery pack, press the two release buttons (7) simultaneously and pull the pack out of the grip. Without the protective cap in place, loose metal objects could short circuit the contacts, causing a fire hazard and damaging the battery pack. [. . . ] Unplug the charger before cleaning the housing with a soft cloth. Remove the battery pack before cleaning your Power Tool. Keep the ventilation slots clear and regularly clean the housing with a soft cloth. If you are not completely satisfied with the performance of your DEWALT tool, simply return it within 30 days, complete as purchased, to the point of purchase, for a full refund or exchange. [. . . ]