User manual DEXAPLAN BA 611 8-2007

[. . . ] Plan where you are going to locate the device. Please read carefully and completely through these operating instructions and fold out page 3, the page with the illustrations. These operating instructions form part of the product and contain important information about bringing the product into use and its handling. If you have any questions or are unsure of how to handle the device please consult our Internet page at www. [. . . ] Press the OK key y Wait 10 seconds until the device automatically quits the settings mode. Switching automatic dialling on / off: You can switch off the automatic dialling function. The device calls all the stored telephone numbers if the automatic dialling function is switched on when an alarm is triggered. The LC display shows if the automatic dialling function is not switched on. factory setting: "CALL ON" (dialling function switched on) Enter the current password. Press the PROG key r until the symbol flashes at the top of the LC display w. Press the OK key y Use the key o and key i to select "CALL ON" (dialling function switched on) or "CALL OFF" (dialling function switched off). Press the OK key y Wait 10 seconds until the device automatically quits the settings mode. Selecting the number of dialling processes: You can select the number of times the automatic dialling function dials the numbers as between once and 5 times. Every stored telephone number will be called this number of times, whether or not the call is answered. Factory setting: 3 times Enter the current password. Press the PROG key r until the word "CYCLE" flashes at the top of the LC display w. Press the OK key y Using the key o and the key i select the number of automatic dialling processes (1/2/3/4/5). Reset: If you wish to delete all the settings or you have forgotten your password, you can initiate a reset as follows: Keep the PROG key r pressed until you hear a pip sound. Now immediately press the Pause key t until you hear a pip sound. now remove the battery and disconnect the mains adapter. After 2 minutes insert the battery again and/or reconnect the mains adapter. Now all the factory settings and the factory-installed password ("000") are restored. To limit the detection angle use one of the two supplied masking stickers W (complete or cut to size). I You can disable the motion detector by applying the whole masking sticker, e. Arming the alarm and emergency telephone dialler: Arming with the remote control Press the key on the alarm unit Enter the current password. The alarm unit sounds three pips and "ARM" appears at the bottom of the LC display w. [. . . ] Before you clean the device, pull the mains adapter out of the mains socket. Use a dry or slightly moist cloth for cleaning the device. Do not use solvents to clean the device. The called number does not receive a call on alarm. [. . . ]