User manual DEXAPLAN TA 603 10-2006

[. . . ] Door alarm TA 603 Dexaplan A max. 10 mm Area of use P O QW E R Technical data Operating voltage: Current consumption: Power supply: 3V DC max. 200 mA 2 x batteries of type LR03 ­ 1. 5 V (AAA) Sensors: 2 x magnetic switches in the side areas of the device casing Switching distance: approx. 15 mm Alarm signal sound level: approx. 95 dB(A) at 1 meter distance Alarm duration: max. [. . . ] Never bring the device close to fire, heat or long exposure to temperatures over 50 °C!Always ensure that the batteries are not short-circuited or thrown into fire. The batteries must also never be recharged. Take care to prevent all damage to pipes and connections for gas, electricity, water or telecommunications. Damage to gas pipes can lead to explosion and risk to life and limb. Damage to electrical connections can lead to mortal danger from electric shock. Damaged water pipes can result in material damage from leaked water. To identify any such damage use suitable detectors or consult a specialist. Avoid operating the device close to ears and do not expose yourself to the loud alarm signal over a longer period, as this could lead to serious damage to your hearing!Never have the device operate close to sick or handicapped people or animals!The state of shock resulting from the loud alarm signal could cause mortal danger and risk of injury!Leaking or damaged batteries can cause acid burns if they come in contact with skin. Therefore always use suitable protective gloves when handling. Proper use This door alarm is suitable for monitoring doors. The device is designed exclusively for operation in dry, enclosed spaces in private households. This product is only licensed for operation with two batteries of type LR03 ­ 1. 5 Volt (AAA). Any other use or modification of the device constitutes improper use and poses a serious risk of accident. The manufacturer is not liable for damage caused by improper use or incorrect operation of the device. Assembly with adhesive strip Use the adhesive tape y + i to affix the door alarm and the magnet to e. g. Assembly of the door alarm o Remove the protective film from one side of the adhesive tape. o Stick the adhesive tape y flush and fully onto the mounting surfaces of the door alarm casing { + } . o Remove the protective film from the other side of the adhesive tape. o Affix the door alarm at the marked position on the door leaf. o Remove the marked outline of the casing. [. . . ] The arrow mark points towards the ON position and the LED lights up green for approx. During this time you may leave the room. The alarm function is activated as soon as the illuminating diode is switched off. During the delay time after the door has been opened, the illuminating diode lights red for 12 - 18 seconds. [. . . ]