User manual DEXAPLAN TM 605

[. . . ] Pressure mat TM 605 A Q B P E R O I U T Y Alarm unit (see Fig. B): E Loudspeaker T Battery compartment U Battery compartment cover O Cable · R Y I P Fixing holes (two on the reverse side of the device) Battery clip Cable plug Function switch · · W Technical data Sensor: Operating voltage: Power supply: Power consumption: Functions: Acoustic signal (volume): Operating and safety instructions Introduction Please read the operating instructions thoroughly and carefully before initial operation of the product. The instruction manual is part of this product and contains important information relating to initial operation and handling. Please always observe all safety instructions. [. . . ] Before assembly and initial operation of the device, check that the delivery is complete and undamaged!The device must only be repaired by authorized and skilled specialists!Otherwise there is a risk of damage resulting from improper use and loss of the warranty. When positioning the pressure mat, make sure that: - there are no pointed or sharp-edged objects underneath it. - the surface on which it is laid is even and smooth. - it is covered by a thin, flexible carpet, a cloth or a doormat to conceal it from view. Use the alarm unit at temperatures of 0°C to + 40°C and the pressure mat at temperatures of -15°C to +40°C!Higher or lower temperatures may adversely affect operation. Safety instructions The following instructions are for your own safety and satisfaction when operating the TM 605 pressure mat. Please note that non-compliance with these safety instructions can lead to a serious risk of accident. Explanation of the symbols and terms used: · · · Position Position of the pressure mat Tip !Do not use a stiff carpet or doormat to cover the pressure mat, since it reacts to points of pressure. If the floor and/or the underside of the carpet or doormat is uneven, malfunctions may occur. Always spread the pressure mat out on a clean and even surface. stones or grit, since these can cause malfunctions or irreparably damage the pressure mat. Detecting people Choose the area in which the pressure mat is to detect the presence of people, e. g. in the entrance area or in front of an area you wish to protect. Spread the pressure mat out completely on the floor/surface and smooth it out flat and even (see Fig. Cover the full surface of the entry mat with a cloth, carpet or a doormat. Pack contents 1 1 2 2 1 pressure mat (including approx. 60 cm cable) alarm unit (including approx. 940 cm cable) fastening screws wall plugs operating instructions Danger !Failure to observe this instruction endangers life and health. Failure to observe this instruction endangers property. Tip ! [. . . ] An active loading of the pressure mat causes the chosen signal to be generated. For example, if a cat walks onto the pressure mat, the alarm unit will generate the signal for the activated function. As long as the cat remains on the pressure mat, there is no active pressure load and therefore no signal is generated. The sensor film inside the pressure mat is highly sensitive. It is possible that it could be triggered by other animals or even by strong wind. [. . . ]