User manual DEXAPLAN WA 620

[. . . ] 130 mA 9-V-Block 6LR61, alkaline (not supplied) Warning signal (approx. 90 dB(A) / 1 m) two short bleeps approx. every 2 minutes +1 °C to +40 °C approx. [. . . ] Power the appliance using a 9 V block battery only!Avoid the alarm unit coming into contact with moisture. Remove the battery when the appliance is not used for a long time. Functioning test !The warning signal or the melody sounds until the sensor contacts [6] have dried. Make sure that the warning signal/ the melody can be heard well. Battery warning Should the appliance peep twice, one shortly after the other, approx. every 2 minutes, then the battery must be replaced. The battery warning signals for up to 21 days. Positioning !Place the water alarm close to a position which you would like to monitor or which is at risk of water escaping e. g. cellar, bathroom, laundry room, kitchen. Place the sensor at the desired monitoring position. Whilst doing so make sure that the length of the connecting cable reaches the position where the alarm unit will be mounted. The height of the sensor contacts determines the water level at which an acoustic alarm is triggered. Place the alarm unit above the monitoring position so that it is not in an area endangered by water. Troubleshooting Fault Cause Remedy The appliance gives no - There is no battery connected - Connect a battery warning signal and no melody - The battery has run down - Insert a new battery even when the sensor contacts - The sensor contacts are dirty - Clean the sensor contacts come into contact with water The sound level is weak or the The battery has run down appliance bleeps approx. every 2 minutes Insert a new battery Mounting Sensor !Position the sensor [7] at the desired position either by # laying the sensor on the surface with the sucker facing upwards # or firmly pushing the sucker [9] onto the surface. The surface here must be smooth and clean otherwise the sucker will only adhere for a short time. Alarm unit # Positioning without fixing ! [. . . ] To activate the water alarm set switch [3] to (melody) or (warning signal). 4 seconds the alarm unit emits a short signal tone. When both sensor contacts [6] come into contact with water the alarm unit triggers either a warning signal (setting ) or a melody (setting ). [. . . ]