User manual DFI CA61

[. . . ] B+ System Board Users Manual 41730039 Copyright This publication contains information that is protected by copyright. No part of it may be reproduced in any form or by any means or used to make any transformation/adaptation without the prior written permission from the copyright holders. This publication is provided for informational purposes only. The manufacturer makes no representations or warranties with respect to the contents or use of this manual and specifically disclaims any express or implied warranties of merchantability or fitness for any particular purpose. [. . . ] Video Off After N/A The system BIOS will never turn off the screen. Suspend The screen is off when the system is in the Suspend mode. Standby The screen is off when the system is in the Standby mode. Standby Mode This is user configurable only when the Power Management category is set to User Defined. When enabled and after the set time of system inactivity, video will be shut off while all other devices still operate at full speed. 41 3 Award BIOS Setup Utility Suspend Mode This is user configurable only when the Power Management categor y is set to User Defined. When enabled and after the set time of system inactivity, the CPU and onboard peripherals will be shut off. HDD Power Down This is user configurable only when the Power Management categor y is set to User Defined. When enabled and after the set time of system inactivity, the hard disk drive will be powered down while all other devices remain active. Soft-Off by PWR-BTTN This category allows you to select the method of powering off your system. Regardless of whether the Power Management field is enabled or disabled, if the power button is pushed and released in less than 4 sec, the system enters the Suspend mode. The purpose of this function is to prevent the system from powering off in case you accidentally hit or pushed the power button. Push and release again in less than 4 sec to restore. Pushing the power button for more than 4 seconds will power off the system. Instant-Off Pressing and then releasing the power button at once will immediately power off your system. PWR Lost Resume State Keep Off When power returns after an AC power failure, the systems power is off. You must press the Power button to power-on the system. Turn On When power returns after an AC power failure, the system will automatically power-on. Last State When power returns after an AC power failure, the system will return to the state where you left off before power failure occurs. If the systems power is off when AC power failure occurs, it will remain off when power returns. If the systems power is on 42 Award BIOS Setup Utility when AC power failure occur s, the system will power-on when power returns. Resume On Ring With an external modem installed, the Modem Ring-on function will allow your system to power-on to respond to incoming calls. By default, the Resume on Ring field is Disabled. [. . . ] If your hard drive takes an excessively long period of time to format, it is likely a cable connection problem. However, if your hard drive has a large capacity, it will take a longer time to format. B Parallel Port The parallel printer doesnt respond when you try to print. Make sure that your printer is turned on and that the printer is on-line. Make sure your software is configured for the right type of printer attached. [. . . ]