User manual DFI LANPARTY UT NF4 ULTRA-D

[. . . ] System Board User's Manual 84720504 Copyright This publication contains information that is protected by copyright. No part of it may be reproduced in any form or by any means or used to make any transformation/adaptation without the prior written permission from the copyright holders. This publication is provided for informational purposes only. The manufacturer makes no representations or warranties with respect to the contents or use of this manual and specifically disclaims any express or implied warranties of merchantability or fitness for any particular purpose. [. . . ] By default, the system boots up with NumLock on wherein the function of the numeric keypad is the number keys. When set to Off, the function of the numeric keypad is the arrow keys. 82 BIOS Setup Typematic Rate Setting Disabled Continually holding down a key on your keyboard will cause the BIOS to report that the key is down. Enabled The BIOS will not only report that the key is down, but will first wait for a moment, and, if the key is still down, it will begin to report that the key has been depressed repeatedly. For example, you would use such a feature to accelerate cursor movements with the arrow keys. You can then select the typematic rate and typematic delay in the "Typematic Rate (Chars/Sec)" and "Typematic Delay (Msec)" fields below. Typematic Rate (Chars/Sec) This field allows you to select the rate at which the keys are accelerated. Typematic Delay (Msec) This field allows you to select the delay between when the key was first depressed and when the acceleration begins. Security Option This field determines when the system will prompt for the password - everytime the system boots or only when you enter the BIOS setup. Set the password in the Set Supervisor/User Password submenu. System The system will not boot and access to Setup will be denied unless the correct password is entered at the prompt. Setup The system will boot, but access to Setup will be denied unless the correct password is entered at the prompt. APIC Mode Leave this field in its default setting. 3 83 3 BIOS Setup MPS Version Control for OS This field is used to select the MPS version that the system board is using. OS Select for DRAM > 64MB Select the "OS2" option only if the system that is running an OS/2 operating system has greater than 64MB RAM. Capability The system board supports SMART (Self-Monitoring, Analysis and Reporting Technology) hard drives. SMART is a reliability prediction technology for ATA/IDE and SCSI drives. The drive will provide sufficient notice to the system or user to backup data prior to the drive's failure. If you are using hard drives that suppor t S. M. A. R. T. , set this field to Enabled. SMART is supported in ATA/33 or later hard drives. Delay for HDD (Secs) This field is used to select the time that would delay the HDD controller's initial time. This is specially useful for some HDDs which will not be ready at first boot when you power-on the system. Full Screen Logo Show This field is applicable only if you want a particular logo to appear during system boot-up. The logo will appear in full screen during system bootup. [. . . ] If your hard drive takes an excessively long period of time to format, it is likely a cable connection problem. However, if your hard drive has a large capacity, it will take a longer time to format. Parallel Port The parallel printer doesn't respond when you try to print. Make sure that your printer is turned on and that the printer is on-line. Make sure your software is configured for the right type of printer attached. [. . . ]