User manual DHI INTERCONNECTION KIT FOR MPG1 WITH RPM4 OR PG 7302 PN 402265 INSTRUCTION SHEET

[. . . ] Interconnection Kit For MPG1 with RPM4 or PG 7302 P/N 402265 Instruction Sheet INTERCONNECTION KIT FOR MPG1 WITH RPM4 OR PG 7302, P/N 402265, INCLUDES: DESCRIPTION QTY PART NO. DH500 6 in. DH500 tee DH500 plug Adaptor, DH500F x 1/8 in. NPTM 1 1 2 1 1 2 100208 100209 123019 100291 100285 102819 Install nipples into three way tee: Install the 5 in. [. . . ] nipples: Slide a gland over a nipple so that the gland's threads face outward. Next, screw a collar onto the nipple by turning it to the LEFT. Allow two nipple threads to show between the collar and nipple tip. a Figure 1: Two nipples installed in 3-way tee. Optional: Extend the front feet on RPM4: The RPM4's front feet can be extended so that the RPM4 is inclined for easier reading and display access. RPM4 A70M or less - install NPT adapter into RPM4. RPM4s that have ranges less than 70 MPa (10, 000 psi) have 1/8 in. These ports require the use of one of the DH500F by 1/8 in. Wrap Teflon thread tape around the NPT adapter's threads three times, and install the adapter into the RPM4. Install the free end of the center nipple into RPM4 or PG 7302: The center, thin, 5 in. nipple should be inserted into the RPM4's or the PG 7302's test port. The nipple can be bent slightly to ensure that nipple enters straight into the test port. Do not tighten the gland in the RPM4 or PG 7302 yet, since it will be tightened when the system is primed. RPM4 ­ Install glands and collars onto the 6 in. PG 7302 ­ Install glands and collars onto the 12 in nipple. b Install the 6 in. Install a DH500M to 1/8" NPT male adapter in the DUT if necessary: The 1/8 in. NPT adapter can be used to connect the remaining thin 5 in. nipple to DUTs with 1/8 in NPT female ports. If you intend to use the NPT adapter, wrap Teflon thread tape around its threads three times and install it into the DUT. [. . . ] Make sure that all air is purged from the test lines. There are 3 loose fittings: one on the DUT, one on the RPM4 or PG 7302, and the other is the plug. Tighten each of the loose fittings when oil without bubbles begins to flow through it. Document 560080 050815 DH Instruments, Inc. 4765 East Beautiful Lane Phoenix AZ 85044-5318 USA Tel 602. 431. 9100 Fax 602. 431. 9559 dhi@dhinstruments. com www. dhinstruments. com [. . . ]