User manual DICOTA DATABOX PROFILE

[. . . ] For more information please consult your dealer or check www. Com for information which Notebooks are compatible. General information - Work environment - Operational current Scope of supply Interior features - Case lid - Case Installation of mobile printer Installation of power socket Storage of power supply units Connection: Notebook and printer 6 6 7 7 7 7 7 8 9 9 10 In general, please take care to operate your DataBox Profile 15" on a stable and skid-fast surface. [. . . ] 4; the white tape must still be removed, the Velcro pads can also be placed in the center of the printer). Before you mount the printer, please check the intended position on the flap since incorrect mounting can cause problems during printer operation. 3) The easiest way to mount the printer is on the open front flap. Mount the printer with its back side (battery side) on the closed cable box in the center and press against the lid. The further back you mount the printer the better for balance, since then the DataBox Profile 15" does not tip over so easily. The printer must first be shoved into the , , QuickFix" printer holder (Fig. The holder with the printer is then placed on the printer lid and connected to the other holders (Fig. 6 (3)) must be fully inserted into the holders on the printer lid. Due to the fact that DataBox Profile 15" is based on the "Floor-to-Desk" system and the Notebook is operated on a table outside the case, the installation of the printer to the Notebook must be done according to the standard installation procedure of the printer or Notebook. How to connect the Notebook with the printer is explained on page 10!*Depending on the printer, there may be other , , QuickFix" holders similar to the one shown!Installation of power supply Installation of power supply 1) 2) Take the remaining four Velcro pads and press two corresponding pairs together. Now you have two Velcro pad pairs with a protective film on each side (also see Page 3, Fig. Remove the film on one side of each pad pair and press this side to the bottom of the synthetic box. press the divider pads to the back side of the DataBox Profile 15". Now you can attach the synthetic box to the left inner side of the DataBox Profile 15" by removing the remaining protective films. You must first insert the power plug through the round opening (!(This can be done on the left or right side. [. . . ] Always place your Notebook in the middle compartment between the divider pads, front side down, to prevent damaging Notebook cables and plugs. Before connecting the multi-plug cable to a power socket, read the manual of your Notebook and/or printer carefully. (This cable is not included in the scope of supply). [. . . ]