User manual DICOTA DATACOURIER

[. . . ] For more information please consult your dealer or check www. Com for information which Notebooks are compatible. General information - Work environment - Operational current Scope of supply Features - Case features Installation of mobile printer Installation of power socket Storage of power supply units Connection: Notebook ­ printer 6 6 7 7 7 7 8 9 9 10 In general, please take care to operate your DataCourier on a stable and skid-fast surface. [. . . ] (1) (2) (3) (4) (5) (6) 1 x 220 V power socket, cable tree 2 x EURO 8 and 2 x IBM Synthetic box with cable tree 8 x 3M Velcro pads (self-adhesive) 3 x keys Removable briefcase Padded shoulder strap (1) (2) (3) (4) (5) (6) (7) Padded Notebook compartment Document compartment Specially fitted ABS box for power supply units Two side pockets on each side Two combination locks Reinforced handle Removable briefcase Open your DataCourier and proceed as follows: 1) 2) Take four Velcro pads and press two corresponding pairs together. 1 showing a pair being pressed together) Now you have two Velcro pairs with protective films on each side. Remove the protective film on one side of each pair to reveal the adhesive tape beneath and press them to one corner each of your printer. 2; the white tape must still be removed, the Velcro pads can also be placed in the center of the printer) Before you mount the printer, please check the intended position on the flap since incorrect mounting can cause problems during printer operation. 3) The easiest way to mount the printer is on the open front flap. Mount the printer with its back side (battery side) on the closed cable box in the center and press against the lid. The further back you mount the printer the better for balance, since then the DataCourier does not tip over so easily. Installation of power supply Installation of power supply 1) 2) Take the remaining four Velcro pads and press two corresponding pairs together. Now you have two Velcro pad pairs with a protective film on each side (also see Page 3, Fig. Remove the film on one side of each pad pair and press this side to the bottom of the synthetic box. press the divider pads to the back side of the DataCourier. Now you can attach the synthetic box to the left inner side of the DataCourier by removing the remaining protective films. You must first insert the power plug through the round opening (!) to the side pocket (This can be done on the left or right side). In case a Velcro pad is already attached to the inner left side, you need only remove the protective film of the corresponding side and attach it to the bottom side of the synthetic box (Fig. Storage of power supply units Storage of power supply units How to store the power supply units: The power supply units are stored on the inside of the synthetic box. [. . . ] 2) Data transfer between printer and Notebook via Bluetooth: (only possible if Notebook and printer are Bluetooth-compatible!Always place your Notebook in the middle compartment between the divider pads, front side down, to prevent damaging Notebooks cables and plugs. Before connecting the multi-plug cable to a power socket, read the manual of your Notebook and/or printer carefully. [. . . ]