User manual DICOTA DATADESK 450

[. . . ] Dear Customers, We would like to thank you that you bought a DICOTA product. Before you use your DataDesk 450 for the first time please read the following user manual thoroughly. Com to find out which Notebooks are suitable. [. . . ] The case should not be immediately closed after the equipment has been used for a long period of time, so as to ensure a cooling-off period!Please keep in mind that the line cord is to be attached to the case first, and then connected to the power source, when connecting with the power supply system!The DataDesk 450 should always be opened during the recharging procedure of the equipment!1 x 220 V ­ IEC plug 1 x USB printer cable (360° pivotable) 8 x 3M Velcro ­ pads (self-adhesive) 4 x Synthetic corners for notebook fastening Lockable box, 2 x keys (1) (2) (3) Document / printer paper compartment Accessory compartment with combination lock Accessory compartment 2) Fit for your printer (HP DJ 450) Cable routing help Stow-away pocket for CD-ROM, 3, 5" FDD, etc. Stow-away pocket for printed paper Stow-away pocket for notebook power supply with plug for a Euro 8-socket (with / without ground wire) Stow-away pocket for printer power supply with plug for a Euro 8-socket (with / without ground wire) Notebook strap Flap lid (not seen in Fig. Installation of your mobile printer Installation of your mobile printer 1) Remove the flap lid from the bottom part of the case, which functions as your Notebook workspace. 2) Place the printer power supply in the front pocket of the bottom part of the case (pocket No. 3) Now connect the Euro 8 plug with the 220 V socket of the power supply (in pocket No. 4) Route the printer power cable through the designated groove (under the flap lid) and sideways past the printer (Fig. Pay attention to a clean cable routing to prevent damaging the printer cable (e. 5) The power supply outlet plug is now connected to the printer. Installation of your Notebook Installation of your Notebook 1) 2) 3) 4) Place the Notebook power supply in the rear pocket of the bottom part of the case. Now connect the 220 V plug with the Notebook's power supply. Route the low voltage power supply outlet cable beneath the flap lid through the designated groove, so that the cable can not be damaged when the lid is closed!The power supply outlet plug is now connected with the Notebook. Now you have two options of fastening your Notebook: 1) Either you use the four synthetic corners which are provided within the scope of supply and fasten them by using the eight self-adhesive 3M Velcro pads (Fig. [. . . ] The Notebook establishes the data connection via Bluetooth through an internal interface or a PC card module. The printer can be connected with a compact flash module, for example. Make sure that no cables are pinched when closing the case! [. . . ]