User manual DICOTA KANGAROO

[. . . ] 1 1 1 1 1 Receiver Wireless mouse USB cable AAA size Ni-MH battery User manual Please read the instruction for installing, operating, and using Kangaroo 2. Compact and ergonomic design USB receiver, Plug & Play 3-button optical mouse perfectly for Notebook users 800 dpi high-resolution optical mouse Application of radio frequency technology and optical sensor technology Cut off power when receiver is stored Driver free Rechargeable and low power consumption. Please make sure that you have read and completely understand this user manual before using it. Be aware of the following tips during operation ⷠPlease do not use or operate any wireless radio frequency products on the aircraft. [. . . ] ­ Please do not use different types of battery at the same time. ⭠Please follow the instructions of battery manufacturers to handle the exhausted batteries. ­ If a consumer uses batteries improperly, it is likely to cause battery broken or liquid leaked, and will result in a burn or injury. Therefore, please do not disassemble, throw into fire, or put in 100° C place or boiling water. Furthermore, please also avoid misplacing battery positive and negative into compartment or put the Alkaline batteries in a battery charger. If batteries touch rings, bracelets, or keys, it is likely to cause a short to enable batteries heated. Sometimes it will cause battery broken or liquid leaked. We suggest that you take out of batteries to store in a dry and ordinary temperature place if it is not for long time use. Take the receiver out of mouse press the eject button on the bottom of the mouse. Take the receiver out of the compartment. When the receiver is in the compartment of the mouse, power supply is automatically off to stop power consumption!Take out the exhausted batteries and replace with new ones. After replacing new batteries, please reconnect your mouse and the receiver!Take out the receiver from the mouse compartment. Plug it into USB port of your Desktop/Notebook. 0 doesn't work smoothly, please adjust the angle of the antenna stick on the side of the receiver to improve it!How to link your optical mouse and receiver The receiver and the mouse will be automatically connected when the receiver is plugged into the USB port of the Desktop/Notebook. Make sure that the Ni-MH batteries are installed in the mouse. Plug the USB connector of the cable into the USB port of the Desktop/Notebook, and the other end into the port in the front of the mouse. 0 implements a non-mechanical tracking engine, based on optical navigation technology, which measures changes in position by optically acquiring sequential surface images (frames) and mathematically determining the direction and magnitude of movement. [. . . ] Please keep iron-made office partitions, computer chassis, monitors, zip-drives, speakers, and switching power supply at least 20 cm from the mouse and receiver. If your cursor is controlled by another mouse in a multi-user environment, please proceed Switch security ID of Kangaroo 2. Please check the USB receiver is properly installed into the USB port of your Notebook. ⷠIf your mouse does not work smoothly when the receiver is installed in USB HUB, please install the receiver in the USB port of your Notebook. [. . . ]