User manual DIGITECH BLACK13

[. . . ] In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. NOTE:The information contained in this manual is subject to change at any time without notification. Some information contained in this manual may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed. The information contained in this version of the owner's manual supersedes all previous versions. 1. [. . . ] Pedal Controls Low Frequency Boost/Cut in models 1-6, and the amount of pitch shift in model 7. 3. AC Adapter Jack Press the pedal to turn the effect on and off. 9. OUT 1 (AMP) Connect only the included DigiTech® PS200R (9V DC) power supply to this jack. 4. CONTROL 2 Please refer to the Knob Function Descriptions section on the following pages for a more detailed explanation of each model. 6. INPUT Connect this output jack to your guitar amplifier. 10. Indicator LED This LED indicates when the effect is turned on. If the LED becomes dim or does not light when using battery power (with the cables connected), the battery needs to be replaced. OUT 2 (MIXER) This output has been specifically designed for use with a full range audio system. It is designed to be plugged directly into a mixer or recording device for optimal performance. Controls High Frequency Boost/Cut in models 1-6, and the delay length in model 7. Connect your instrument to this jack. Connecting a guitar cable to this jack supplies battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables when not in use. 7. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these Model Descriptions MODEL 1. "I Am the Law, " Anthrax ­ Among the Living (1987) Model 1 captures the clearer, more sizzling distortion tone Scott used for "I Am the Law". Use the CONTROL 1 knob to boost or cut the low frequencies. Use the CONTROL 2 knob to boost or cut the high frequencies. "Madhouse, " Anthrax ­ Spreading the Disease (1985) Model 2 generates the more refined tone Scott used in "Madhouse". Use the CONTROL 1 knob to boost or cut the low frequencies. Use the CONTROL 2 knob to boost or cut the high frequencies. (1985) This is the classic "grind" distortion tone Scott pioneered and utilized in "March of the S. O. D. ". Use the CONTROL 1 knob to boost or cut the low frequencies. Use the CONTROL 2 knob to boost or cut the high frequencies. NOTE: Set the CONTROL 1 and CONTROL 2 knobs to the 12 o'clock position to most accurately recreate each tone as it sounds in the original recordings. MODEL 4. [. . . ] 6. Turn up your amplifier/mixer level to your desired listening level. 7. Turn on the pedal by pressing the pedal switch and gradually turn up the pedal's LEVEL control to the desired listening level. Connections The Black-13TM pedal features a single INPUT and a pair of outputs, OUT 1 (AMP) and OUT 2 (MIXER). The two outputs give you the option of running into a guitar amplifier, running directly to a mixing console, or both at the same time. The OUT 2 (MIXER) output has been specially designed to faithfully reproduce Scott's studio guitar amplifier tones without having to use an amp. [. . . ]