User manual DIGITECH BP200

[. . . ] MODELING BASS PROCESSOR User's Guide Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. ) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. These symbols are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash means that there are dangerous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owners manual. These symbols warn that there are no user serviceable parts inside the unit. [. . . ] To access the Tuner do the following: 1. Press and hold both foot switches until TUNER appears in the display. Begin playing and the note appears in the display. The Matrix LED's indicate whether the note is sharp (red LED's lit above the green CABINET-GATE LED ) or flat (red LED's lit below the green CABINET-GATE LED). When the note is in tune, only the green CABINET-GATE LED is lit. Press the SELECT button to select the tuning reference (A=440, A=Ab, A=G, A=Gb) 4. Rotate the AMP TYPE, GAIN, and MASTER LEVEL knobs to change the tuning reference in semitone steps. This setting is maintained until changed by the user or a factory reset is performed. 12 5. Press either of the 2 foot switches to exit the Tuner mode, and returns you to the last mode used. Display Shows Note Played Top LEDs Indicate Note is Sharp Green LED Indicates Note is In Tune tuner Bottom LEDs Indicate Note is Flat Note:The STORE and RHYTHM buttons are disabled in Tuner mode. The EXPRESSION PEDAL returns sound to the signal and acts as bypass volume. 13 Rhythm Trainer The BP200 includes 31 sampled drum patterns that may be used to develop a good sense of timing. To use the Rhythm Trainer, do the following: 1. Rotate the AMP TYPE knob to select 1 of the 30 patterns available. Rotate the GAIN knob to set the pattern tempo (40-240BPM). Rotate the MASTER LEVEL knob to adjust the rhythm playback level (0-99). Press the RHYTHM button again to exit the Rhythm Trainer. All rhythm settings are maintained until the BP200 is powered off. Note: Press the SELECT button to return to Edit Mode. Press the STORE button to return to Store Mode. Press either footswitch to return to Performance Mode with the Rhythm Trainer playback still enabled. Expression Pedal Assigning a Parameter The BP200 includes a built-in Expression pedal. The Expression pedal is used to control many of the BP200's effect parameters in real time. To assign a parameter to the Expression pedal, do the following: 1. Press the SELECT button until the Matrix's last effect row LED begins flashing. [. . . ] Amount - Rotate the GAIN knob to adjust the speed at which the pitch modulates (1-99). Effect Level - Rotate the MASTER LEVEL knob to adjust the depth of the modulation (0-99). 22 Octavider The Octavider effect creates a smooth tracking unison note one octave below the note being played. Amount - Has no function when Octavider is used. Effect Level - Rotate the MASTER LEVEL knob to adjust the level of the Octavider effect (0-99). SynthTalkTM SynthTalkTM is exclusive to DigiTech. [. . . ]