User manual DIGITECH BP50

[. . . ] MODELING BASS PROCESSOR User's Guide Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. ) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. These symbols are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash means that there are dangerous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owner's manual. [. . . ] Connect the other end of the PS200R power supply to an AC outlet. Turn your amplifier(s) on and adjust the volume(s)to a normal playing level. About the BP50 The Presets Presets are numbered locations of programmed sounds. Presets are recalled with the Footswitches. The BP50 comes with 40 User Presets (Presets 1-40) and 40 Factory Presets (Presets 41-80). The User Presets are locations where you can store presets. The Factory Presets may not be saved over. From the factory, the 40 User Presets are exact duplicates of the 40 Factory Presets. Play Mode When you first apply power to the BP50, it powers up in Play mode. The far left LED lights, indicating you're in Play mode. In Play mode, use the Up and Down Footswitches to access the presets. 8 Tuner The Tuner in the BP50 lets you quickly tune or check the tuning of your bass. Press and hold both Footswitches simultaneously to access the tuner. A tu briefly displays indicating that you are in Tuner mode. To begin tuning, play a note on your bass (the neck pickup usually works best). The display shows the note being played. The Effect LEDs indicate whether the note is sharp or flat. The right 6 red LEDs indicate the note is sharp and should be tuned down. The left 6 red LEDs indicate the note is flat and should be tuned up. The center Green LED indicates the note is in tune. The output is muted in Tuner mode. The display shows the note played. a LEDs to the left of the EQ LED indicate the note is flat. The following steps outline how to store changes to a preset or copy a preset to a different location: 1. Press the STORE button again to save your changes. 2. Use the footswitches to select the preset location you want to store your changes to. 1. The current preset location flashes in the display. [. . . ] The higher numbers indicate there is more reverb level. The reverb settings are as follows: r1-f9 = Room H1-H9 - Hall P1-p9 - Plate C1-C9=Church A1-a9 = Arena S1-s9 - Spring 19 Other Functions Expression Pedal The rear panel of the BP50 includes an input for an expression pedal. Any passive volume pedal can be used as an expression pedal with the BP50. Connect from the output of a passive volume pedal to the Expression Pedal Input on the BP50. [. . . ]