User manual DIGITECH C8

[. . . ] The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. Proof-of-purchase is considered to be the burden of the customer. DigiTech reserves the right to make changes in design, make additions to, or improvements upon this product without incurring any obligation to install the same on PRODUCTS PREVIOUSLY MANUFACTURED. [. . . ] To exit this mode, simply press any one of the numbered footswitches. The value is now stored into memory. Pedal Description Toggle CC Status 8888 Bank Ch: Channel P: Pedal CC Number Program Selection / Program Mode CC 25 MIDI CHANNEL MODE SELECT CC 24 PEDAL CC NUMBER The Control 8 operates in banks of ten. The far right LED bars in the display indicate whether you are in the lower 5 or upper 5 programs in that bank. To choose a bank, press either the <Up> or <Down> pedal. (MIDI Channel select is between 12 and 0). In a bank, notice that either the lower bar or upper bar is lit in the display. Therefore, if the display reads 6, and the upper bar is lit, the programs selected will be 65-69. When a program change message is sent out, the display will flash 4 dashes. To increment or decrement Banks quickly, press and hold the <Up> or <Down> footswitches. The numbers will change slowly at first, then scroll rapidly. On power-up, the Control 8 defaults to MIDI Channel 1/Program Number 0. The Control 8 only transmits program change numbers 1 through 128, numbers 0 and 129 will not be transmitted. MIDI OUT 9. 6v DC 85 ma CC 21 CC 22 CC 23 The Program Number/Continuous Controller/MIDI Channel display is a 4-digit LED display. The pedals perform the program change and bank up/down functions and can be used as continuous controllers. The back of the unit has a standard 5-pin DIN MIDI jack and a 3. 5mm Power In jack. Connection + - Selecting Hopback Mode The Control 8 offers you the ability to bounce back instantly to the previously selected footswitch value by simply pressing the currently selected footswitch once again and the Control 8 will automatically "Hopback" to previous footswitch. To select this option you must perform the following procedure: · While applying power to the Control 8, press and hold the <3> footswitch. Now press the <UP> or the <Down> to turn this mode on or off. [. . . ] The program number can be changed using the <Up/Down> footswitches. The · At this point, rock the pedal to its' maximum forward position and press the <Up> footswitch. The upper bar in the display will now blink, prompting you to rock the pedal back to its' minimum position and then press the <Down> footswitch. [. . . ]