User manual DIGITECH DHP33

[. . . ] Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. Opening the chassis for any reason will void the manufacturer's warranty. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. [. . . ] While editing a preset, the LEDs indicate the Effect currently selected for editing. In Tuner mode, the LEDs indicate whether the note played is sharp, flat, or in tune. 6. Matrix 7. Drums The Drums button is used to turn on and off the DHP33's built-in drum machine. When the Drums button is turned on, the Drums button LED lights and the selected drum pattern plays continuously. Use the Value Up/Down buttons to change the pattern of the drum machine. See page 34 for more information about the drum machine. The Store button is used to save your changes to the User presets. See page 18 for more information about storing presets. 8. 9. Store The Expression Pedal provides real-time control of the DHP33's Volume, Wah, or the assigned effect parameter. Expression Pedal 9 Rear Panel 1 2 3 4 5 1. 2. Input Connect your instrument to this high-impedance TS input. Amp / Mixer This button optimizes the DHP33's outputs for use when plugged into a guitar amp or a mixer/recording device. When set to Mixer ("In" position), the outputs are optimized for connecting to a mixer, recording device or headphones. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal playing level. Use the Master Level button and the Value Up/Down buttons to gradually increase the DHP33's Master Level to achieve the desired volume. 2. Connect PS200R to power jack 4. Turn amp volume up 3. Connect PS200R to AC outlet and set the DHP33's Master Level to "0" 5. Set the DHP33's Master Level to the desired listening volume 16 1. Turn amp volume down Section Two - Editing Functions Editing/Creating Presets The DHP33 is designed to make preset editing and creation easy and intuitive. When creating your own sound, you must first start with an existing preset. Note that the preset you begin with doesn't have to be in the memory location you intend to have it reside, since you can store it to any User preset location during the store procedure. The easiest way to start is by using the Tone Library and Effects Library buttons. The Tone Library button gives you access to a variety of pre-programmed amp/distortion tones (see page 38) based on different musical styles. The Effects Library button then lets you select from a palette of effects chains (see page 39), from simple delays to full multi-effect signals with modulation, delay and reverb. Use the Effects Level Button to easily increase or decrease the Chorus/FX, Delay and Reverb levels if desired. [. . . ] The number value shown is the minimum parameter value ­ this is the value that will be reached when the Expression Pedal is rocked back (toe up). The number value shown is the maximum parameter value ­ this is the value that will be reached when the Expression Pedal is rocked forward (toe down). Use the Store procedure (see page 18) to save your changes to the preset. Expression Pedal Assign 32 Expression assignments available are as follows: No Assignment Volume Volume Wah Amp Chorus Flanger Phaser Tremolo Panner Vibrato Rotary YaYa AutoYa Envelope Filter Detune Pitch Shift Whammy Delay Reverb OF Pr (Output Level Pre Delay) PS (Output Level Post Delay) AH (Expression Pedal acts as a Wah pedal) gA (Expression Pedal controls the Amp Gain) SP (Speed) LE (Level) SP (Speed) LE (Level) SP (Speed) LE (Level) SP (Speed) dP (Depth) SP (Speed) dP (Depth) SP (Speed) dP (Depth) SP (Speed) dP (Depth) Pd (Expression Pedal acts as a YaYaTM Effect when engaged) SP (Speed) dP (Depth) ES (Sensitivity) LE (Level of the Detuned signal) LE (Level of the Pitch Shifted signal) HY (Expression Pedal acts as a DigiTech® WhammyTM pedal) dL (Delay Level) dF (Delay Feedback) rL (Reverb Level) 33 Drum Machine The DHP33 features a built-in drum machine, which is enabled by pressing the Drums button. Select patterns, tempo, and level with the Edit Up/Down buttons. [. . . ]