User manual DIGITECH HOTROD

[. . . ] Sandy Parkway Sandy, Utah 84070, USA Date: February 22, 2002 European Contact: Your local DigiTech Sales and Service Office or Harman Music Group 8760 South Sandy Parkway Sandy, Utah 84070 USA Ph: (801) 566-8800 Fax: (801) 568-7583 IEC 60065 (1998) EN 55013 (1990) EN 55020 (1991) WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year (this warranty is extended to a period of six years when the product has been properly registered by mail or through our website). A Return Authorization number may be obtained from DigiTech by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. [. . . ] 2. Tone Knob Controls the boost or cut of high frequencies. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content. AC Adapter Jack Connect a DigiTech PS200R power supply to this jack. Use the proper supply for your area's Mains line voltage. 1 234 5 11 10 9 6 7 8 4. Gain Knob Controls the amount of distortion gain. Turn this knob clockwise to increase the amount of distortion, and counter-clockwise to decrease the amount of distortion. Morph Knob Morphs between the three different distortion voicings the Hot Rod has to offer. The knob's minimum position features a smooth, warm distortion tone. The 12 o'clock position has a classic, edgy distortion sound reminiscent to that of a British Stack. The maximum position gives you a high gain fuzz distortion. Experimenting with different knob positions provides a wide variety of different tones never before available in a single pedal. Input Jack Connect your instrument to this jack. Connecting a guitar cable to this jack engages battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables from the pedal when not in use. 7. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the chassis exposing the battery compartment. Out 1(Amp) Jack Connect this output to your guitar amplifier. Indicator LED Indicates when the effect is turned on. [. . . ] Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. [. . . ]