User manual DIGITECH HYPERPHASE

[. . . ] Sandy Parkway Sandy, Utah 84070, USA Date: May 30, 2002 European Contact: Your local DigiTech Sales and Service Office or Harman Music Group 8760 South Sandy Parkway Sandy, Utah 84070 USA Ph: (801) 566-8800 Fax: (801) 568-7583 IEC 60065 (1998) EN 55013 (1990) EN 55020 (1991) WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year (this warranty is extended to a period of six years when the product has been properly registered by mail or through our website). A Return Authorization number may be obtained from DigiTech by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. [. . . ] Use the proper supply for your area's Mains line voltage. Regen Knob Controls the amount of regeneration (feedback) in the phaser effect. Turn this knob clockwise to increase the regeneration, and counterclockwise to decrease the regeneration. When 4-RISE/FALL is selected, this knob creates a rising sweep when set between the minimum and 12 o'clock positions, and a falling sweep when set between the 12 o'clock and maximum positions. 1 234 5 11 10 9 6 7 8 5. Type Knob Selects 1 of the 7 different phaser effect types. 4-RISE / FALL - Creates a constant rising phaser sound when the REGEN knob is set between the minimum and 12 o'clock positions, or a constant falling phaser sound when the REGEN knob is set between the 12 o'clock and maximum positions. 5-TRIG UP* - The phaser effect starts at the bottom of its sweep when the trigger threshold is reached. Use the REGEN knob to adjust the trigger threshold sensitivity and SPEED knob to adjust sweep rate. Regeneration is fixed when Triggered Up is selected. 6-TRIG DOWN* - The phaser effect starts at the top of its sweep when the trigger threshold is reached. Use the REGEN knob to adjust the trigger threshold sensitivity and SPEED knob to adjust sweep rate. Regeneration is fixed when Triggered Down is selected. 7-STEP - Creates a random square wave phase effect similar to a sample and hold filter on a synthesizer. * Using a distortion pedal before the Hyper Phase may cause inconsistent triggering due to the non-dynamic nature of distorted signals. 6. Input Jack Connect your instrument to this jack. Connecting a guitar cable to this jack supplies battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables from the pedal when not in use. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the pedal chassis exposing the battery compartment. Pedal Press the pedal to turn the effect on and off. Out 1(Mono) Jack Connect this output to a single guitar amplifier or mixer channel when only one amp or mixer channel is being used. [. . . ] Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. [. . . ]