User manual DIGITECH MIDIEQ

[. . . ] do not attempt to service the unit yourself. refer all servicing to qualified personnel. opening the chassis for any reason will void the manufacturer's warranty. if liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. [. . . ] You should have an instrument or audio device connected to the 1/4" inputs or a mic connected to the XLR mic input before proceeding. NOTE: The maximum loop time the JamMan Stereo can record or play is 10 minutes. Select an empty memory location using the LooP seLect knob or the LooP UP/LooP DoWN footswitches (the LooP and sINgLe LEDs will be off). (Optional) If you would like to perform to a guide track, you must set a tempo. The rhythm guide track will not be heard until a tempo has been set. You can set a tempo by tapping the teMPo/stoP footswitch. Adjust the RHYtHM LeVeL knob to a suitable volume. The teMPo/stoP footswitch will now be flashing at the set tempo (see page 42). (Optional) Set the Time Signature to something other than 4/4, if desired (see page 40). Press the Rec/PLaY/oVeRDUb footswitch and begin playing or singing to start recording. If a tempo has been set, there will be a single measure count-in indicated by the teMPo footswitch before recording begins. When you are finished recording, press the Rec/PLaY/oVeRDUb footswitch once to set the loop point and have the phrase play back in a repeating loop. The Rec/PLaY/oVeRDUb footswitch and PLaY status LEDs will light solid green. Press the teMPo/stoP footswitch to stop the loop playback. 2. 5. 6. Once you are finished recording, the stoRe button will be lit indicating the phrase must be stored to memory to be recalled later. 28 Recording a Loop Using Auto Record 2 1 4 3 5 6 29 Recording Overdubs Once a loop phrase is recorded, you can add overdubs over the top of it. Overdubs can only be recorded to Loop phrases and not to Single phrases. Use the seLect knob or the LooP UP/LooP DoWN footswitches to select a previously recorded Loop phrase, or use a newly recorded phrase that has not yet been stored. The LooP LED must be lit if a previously recorded phrase is selected. If the caRD MeM LED is lit, you have selected a loop on the optional memory card. This footswitch and the PLaY status LEDs will light solid green and the phrase will begin playing. Press and release the Rec/PLaY/oVeRDUb footswitch again to begin overdub recording. This footswitch and the oVeRDUb status LEDs will now light solid yellow and any audio introduced on the selected input will be added to the audio the playback. [. . . ] The card must be formatted before the JamMan Stereo can use it. To format the card, follow these steps: 1. While the DIsPLaY reads nF, the stoRe button will begin flashing prompting for a format confirmation. and the stoRe button will continue to flash. [. . . ]