User manual DIGITECH RP155

[. . . ] Modeling Guitar Processor Owner's Manual Safety Information WARNING FOR YOUR PROTECTION READ THE FOLLOWING: KEEP THESE INSTRUCTIONS The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner's manual. These symbols warn that there are no user serviceable parts inside the unit. [. . . ] The Tone Library knob will let you select from a variety of pre-programmed amp/distortion tones (see page 41) based on different musical styles. The Effects Library knob will then let you select from a palette of effects chains (see page 42), from simple delays to full multi-effect signals with modulation, delay and reverb. Use the Effects Level Knob to easily increase or decrease the Chorus/FX, Delay and Reverb levels if desired. Using these three controls should get you close to a sound you are after. From there you can then use the Edit buttons to navigate through the individual effects for some fine tune edits. 16 To edit and create a custom preset: 1. Use the Footswitches to select the preset you wish to edit. If you are trying to find something different from the existing presets, begin by using the Tone Library, Effects Library, and Effects Level knobs to get close to a sound you want. Once you have a sound close to what you are after, begin editing the effect parameters by pressing the Edit Up/Down buttons and selecting the Effect row you want to edit. To turn on or off an Effect row, press Knob 1 and then use Knobs 2-4 to modify the effects parameter settings. Anytime a stored value within a preset is changed, the Store button LED lights up. This indicates that you need to store the changes. Changing presets, or turning the power off before storing any changes erases any edits made and the RP155 will revert to the stored values for the preset. 17 Storing/Copying a Preset Once the preset has been modified to your liking, you may store your settings to any of the 50 User preset locations (presets 1-50). The following steps outline the procedure for storing changes to a preset or copying a preset to a different location: 1. Press the Store button once and the current Preset location will flash in the Display. This is asking you to select a new User Preset location where your new sound will reside. If desired, select a new User Preset location using the Footswitches. 3 Press the Store button again to save the changes. The procedure for copying one Preset to another Preset location is the same. Simply use the Footswitches to select the Preset that you want to copy, then follow the steps listed above. 1. Press the Store button; the Preset number flashes. Press the Store button again to save your changes. 2. Select a destination with the Footswitches. 18 Section Three - Models and Parameters About the Models The RP155 can be thought of as several different "virtual" amplifiers and individual, high-tech stompboxes in a single programmable package. [. . . ] You can resume playback by pressing this footswitch again. To clear a recorded loop, stop the loop playback first as outlined in step 6 and then press and hold left Down Footswitch for 2 seconds until the display reads LC. To exit the Phrase Looper mode, press and hold left Down Footswitch for 4 seconds until the display reads LE and then returns to the preset number display. 36 While the Phrase Looper is active, the left Down Footswitch cannot be used to select presets. The right Up Footswitch can still be used navigate through all of the RP's presets. [. . . ]