User manual DIGITECH RP21

[. . . ] Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. ) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. These symbols are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash means that there are dangerous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owners manual. These symbols warn that there are no user serviceable parts inside the unit. [. . . ] Controls the output level of the left or right side of the flanger. Ranges from Off to 100%. FdBck WvFrm Out A - B Pan A - B Out L - R Pedal Phaser The Pedal phaser is a phaser that can be controlled by an expression pedal to control the depth and feedback of the effect Pedal Phaser Parameters FX and Dry Level Controls the FX and Dry level of the Pedal Phaser module. Balance Pedal Sets the Balance of the effect. This parameter is used to be controlled by the expression pedal to control Depth and Feedback. Range: 0 to 100. 31 RP21D User's Guide Depth Feedback Output A-B Pan A-B Section Two - Editing Functions This parameter controls the amount of modulation depth in the phaser. This parameter controls amount of feedback in the phaser effect. This parameter sets output of the pedal phaser effect. This parameter sets pan of the pedal Phaser Range is from 0 to 100%. Rotary Speaker Simulator The Rotary Speaker Simulator allows you to emulate the classic rotating speaker sound, without the chiropractic problems that come with moving bulky speaker cabinets. The Rotary speaker is directly responsible for some of the most unique sounds in music. The applications for this effect are so diverse, it can be used to achieve sounds ranging from the Allman Brothers Band to the legendary Stevie Ray Vaughan. A unique parameter in the Rotating Speaker simulation is the Acceleration parameter. This parameter is used emulate the the time that it takes to get the Speaker up and spinning at full speed. The parameter can be assigned to a footswitch or the expression pedal so you can control the acceleration speed. Rotary Speaker Simulator Parameters: FX: Lvl Controls the signal input level fed to the Module. Dry: Lvl Balance Mode Spread H - R: Level Controls the level of the dry (uneffected) signal. Controls the positioning of the dry signal in the stereo soundfield. Ranges from -99 (all left) to 99 (all right) Selects which speed mode the Rotor and Horn are in. Sets the overall level of the Rotor or Horn. Ranges from Off to 100%. Slo - Fast Hrn Speed Controls the Low Frequency Oscillator (LFO) speed of the Horn. Slo - Fast Hrn Depth Controls the intensity of the rotating effect. Slo - Fast Hrn Doppler Sets the amount of shifted pitch heard in the Horn. Slo - Fast Rtr Speed Controls the Low Frequency Oscillator (LFO) speed of the Rotor. [. . . ] You will also have to recalibrate the pedal after performing a Factory Reset procedure. The procedure for recalibrating the Expression Pedal is as follows: 1. Use the Next and Previous Page buttons until you reach page 14. The Display reads: FACTORY PAGE 15OF15 b 2 USER Recalibrate Pedal ? 1 Yes LINK CHANGED COMP 2 WAH TUBE DIST LINK CHANGED 1 EQ EQ 3 GATE LINK CHANGED 1 4 LINK CHANGED L/R OUTS # DIGITAL CLIP L/R OUTS 2. [. . . ]